1.
High strength plain washers for steel structures
GB/T1230-1991钢结构用高强度垫圈
2.
" Specifications of high strength bolts with large hexagon head, large hexagon nuts, plain washers for steel structures"
GB/T1231-1991钢结构用高强度大六角头螺拴、大六角螺母、垫圈技术条件
3.
HOW TO IDENTIFY GASKET THICKNESS
如何识别垫圈的厚度
4.
horse shoe washer
开口垫圈,马蹄形垫圈
5.
Production control needs to be informed how many such washers will be needed.
应告知生产调度需要多少这种垫圈。
6.
Research on Characteristics of Hydrodynamic Pressure of Slabs Set in the Ring of Arch Invert Cushion Pool;
反拱水垫塘拱圈底板动水压强变化规律的研究
7.
Washers with ball face
GB/T849-1988球面垫圈
8.
Washers with split
GB/T851-1988开口垫圈
9.
Plain washers--Small series--Product grade A
GB/T848-1985小垫圈--a级
10.
Plain washers--Normal series--Product grade A
GB/T97.1-1985平垫圈-a级
11.
Washers with cone face
GB/T850-1988锥面垫圈
12.
There is high level of equality in Wicca with the emphasis on the circle and the lack of any preaching.
在巫术崇拜里有着高度的平等，强调圆圈（代表平等），不要强行灌输。
13.
Specifications for spring washers--Single coil spring lock washers
GB/T94.1-1987弹性垫圈技术条件弹簧垫圈
14.
Variation pattern of hydrodynamic pressure on arched ring slabs in arch invert water-cushion pool in time and frequency domain
反拱水垫塘拱圈底板动水压强时域与频域的变化规律
15.
Standard finish of gasket surface is125-200 micro-inch maximum roughness.
垫圈表面的标准光洁度最大为125-200百万分之一英寸粗糙度。
16.
A wide range of standard stampings, non-standard products, stainless steel washers, internal/ external teeth washers, rings, circlips for holes, circlips for shaft, other fasteners, fittings, seal washers and clamps主要生产各种标准件冲压件.各种非标产品.
不绣钢垫圈;内外齿垫圈;挡圈;孔用挡圈;轴用挡圈;纱嘴头,其他紧固件、接件密封垫圈卡圈.
17.
Installing bolts allowed to use gas cutting bore hole and never more than two gaskets pad not sexual bolts, exposed screw bolt length of not less than2-3 deduction.
安装螺栓孔不允许用气割扩孔,永乆性螺栓不得垫两个以上垫圈,螺栓外露丝扣长度不少于2～扣.
18.
Temperature limitations of body/ bonnet materials, trim, bolting, packing and gaskets must all be considered.
阀体/盖材料，阀内件，填料和垫圈的温度范围都必须考虑。