1.
Technical improvement for installation of the insulating layer of CPR1000 reactor pressure vessel
CPR1000核反应堆压力容器保温层安装技术改进
2.
Domestic insulated containers
GB/T11416-1989日用保温容器
3.
Code for construction and acceptance of corrosion protection and insulation for steel containers
钢质容器防腐和保温施工及验收规范
4.
The upper surface of the bed remains horizontal when the container is tipped.
当容器倾斜时床层上表面保持水平。
5.
An exploratory investigation on sandwich vacuum of a cryogenic liquid storage vessel in use
关于在用低温液体贮运容器夹层真空度的探讨
6.
Loss of Vacuum Experiment on a Multi-Layer Insulation Vessel;
高真空多层绝热低温容器真空丧失试验研究
7.
Replace the insulation. Make sure the thermostat( s) are well covered. Replace the access cover( s).
重新放好绝缘保温层。确保温控器被完好覆盖。重新安装观察盖板。
8.
Remove the access cover( s) and fold the insulation outward and away from the thermostat( s). Do not remove the plastic cover.
拆卸观察盖板和温控器外部的绝缘保温层。不要拆卸塑料盖。
9.
insulated capacity
保温能力隔离舱容积
10.
For this reason pressurized cryogenic containers are normally protected with multiple devices for over-pressure prevention.
由于这个原因，一般用多种装置来保护受压低温容器，以防止过压。
11.
Cryogenic vessels retained by customers should be periodically tested to confirm that the contents comply with Pharmacopoeial requirements.
用户保留的低温容器应定期检验，以确定其成份符合药典要求。
12.
high vacuum superinsulation cryogenic container
高真空超绝热低温容器
13.
Earthenware has an advantage over wood in being easily kept clean.
陶器与木器容易保洁。
14.
food server, electrothermic, domestic
家用电动仪器保温器
15.
Hydrophobic PTFE production company , the second floor of waterborne coatings and organic silicon Nonstick coatings, which are widely used in food containers and heat - resistant containers.
公司生产的聚四氟乙烯油性、水性二层涂料及有机硅不粘涂料，广泛应用于食品容器、耐高温器皿。
16.
multilayer high pressure vessel
层板包扎式高压容器
17.
Throughout the heating process, the liquid product in the vessel is mixed to ensure uniform temperature rise until the desired temperature is reached.
在整个加热过程中,搅拌容器中的液体产品,以确保温度上升均匀,直到达到所需温度。
18.
Replace the insulation making sure that the controls are well covered and that the plastic terminal shield has not been displaced; then replace the access panel.
把绝缘层重新放在原先的位置,确保温度控制器被绝缘层完全包裹,接着把入口面板重新盖上。