说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 热致微缺陷
1.
Investigation of Thermally Induced Microdefects in 300 mm Heavily Boron Doped Si Substrates Used for Epitaxy
外延用300mm重掺B Si衬底中热致微缺陷研究
2.
Research on the Density Improvment and Micro-defect Elimination during DLMS;
DLMS技术致密度提高及微观缺陷消除的试验研究
3.
The crystal imperfections we consider here are called point defects.
我们认为这里的晶体缺陷是致命缺陷。
4.
RESEARCH ABOUT SCRATCH ON SURFACE OF STRIP STEEL
连续热镀锌沉没辊不转导致带钢划伤缺陷的研究
5.
Effect of Rapid Thermal Annealing on Void Defects and Denuded Zone in Large-Diameter CZ-Si;
快速热处理对大直径直拉硅中空洞型微缺陷及清洁区的影响
6.
Specific Transport Properties Relevant to Crystal Structures and Micro Defects of Thermoelectric Materials
热电材料晶体结构与微观缺陷相关的特异传输性质
7.
Defect Modes Based on Negative Refractive Index Structural Defects Coupled in One-dimensional Photonic Crystals;
一维光子晶体中多负折射率缺陷导致的缺陷模
8.
The goalkeeper is the heel of Achilles.?
那守门员太弱是致命的缺陷。
9.
a failing in the character of a tragic hero that leads to his downfall.
悲剧中人物性格中导致悲剧的缺陷。
10.
Er and Defect Photoluminesence in Hydrogenated Amorphous Silicon;
a-Si:H中的光致Er荧光及缺陷荧光研究
11.
The Importance of Realizing Close Circle of Base Money
我国货币供给的致命缺陷:开放式循环
12.
Thus, the oxygen as primary product should be purified for breath though multistage filters composed with chemical and physical layers.
为解决上述两个缺陷,笔者提出一种新的微波诱导催化技术来代替传统的燃料加热方法。
13.
anoxia resulting from defective oxygenation of the blood in the lungs.
由于血液中的氧化过程有缺陷而导致的缺氧。
14.
"The not sharing of information is what caused September 11. It was not a failure of technology; it was a failure of networking."
信息不共享是导致'9·11'事件的原因,这不是技术缺陷,而是网络缺陷。
15.
A Study on Side Defects of Hot Rolled Q235B and Q345B Strip Steels;
热轧Q235B与Q345B带钢边部缺陷研究
16.
The Study on Infrared Thermal Wave Detection Thchnology for Inner Defects in Casting Product
铸件内部缺陷红外热波检测技术研究
17.
Solutions of Temperature Field of Electric Objects with Defects by Method of Green Function
电热缺陷体温度场的Green函数法分析
18.
Coating surface defect on hot-dip galvanized steel sheet and its preventive measures
热镀锌板镀层表面缺陷及其消除措施