1.
The design of bolt-screwing device for installing a robot on the lighting rod on air bracket grounding wire
高架地线上避雷针安装机器人螺栓拧紧机构的设计
2.
Improper bolt tightening procedure.
螺栓拧紧程序错误。
3.
Hold puller screw and tighten puller nut until bushing is remove
握紧拉拔器螺栓，拧紧拉拔器螺母，直至拆下衬套。
4.
Tighten the engine mount-to-bracket bolts.
拧紧引擎架至支架的螺栓。
5.
Install exhaust heat shield, tighten bolts to 11 N·m.
安装排气隔热罩，拧紧螺栓到11 N·m。
6.
Place the new pump in position and tighten mounting bolts.
使水泵就位，拧紧装配螺栓。
7.
The plumber took out a wrench and tightened the bolt.
管子工拿出一把扳手拧紧了螺栓。
8.
Research on the Screwing Technology & Design of the Screwing Control System;
螺纹拧紧技术研究及拧紧机控制系统设计
9.
Inspect crankshaft, flexplate/flywheel and bolts for damagTighten to correct torque
检查曲轴、活动板/飞轮和螺栓是否松动。拧紧螺栓以校正扭力。
10.
High-strength bolts were inserted into the holes and tightened to a high preload level.
把高强度螺栓插入孔洞，同时拧紧螺栓达到高的预加载水平。
11.
The plumber takes out a wrench and tighten the bolt.
修水管的工人拿出一把扳手拧紧了螺栓。
12.
The plumber take out a wrench and tighten the bolt
修水管的工人拿出一把扳手拧紧了螺栓
13.
After seven days, the grouted mortar will have concreted, then we shall tighten the anchor bolts.
灌浆在七天以后凝固，我们就将拧紧地脚螺栓。
14.
Study on Tightening Moment Test of Joint Bolt in Sandwich of Composites
复合材料夹层连接螺栓拧紧力矩试验研究
15.
Double Nuts Anti-loosening link Assembly Screwing down Process Theoretic Analysis
双螺母防松时螺栓联接装配拧紧工艺的初步理论分析
16.
Gear operator is removed by unscrewing hex head screws which hold operator to valve body.
通过拧松将操作机构固定在阀体上的六角螺栓来拆卸齿轮操作机构。
17.
Connect the exhaust pipe to the turbo down pipe manifolTighten the bolts to 25 N·m torque.
连接排气管道到涡轮下管道歧管。拧紧螺栓到25 N·m扭力。
18.
Add sealed shim between the two flanges and then lock down the bolt.
安装时两法兰间需加密封垫片，然后均匀拧紧螺栓。