说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 探头参数
1.
The simulated models are compared with the experimental characterization of the injection probe, and the result shows the transmission line model is more identical with actual conditions than the lumped-parameter circuit model.
并将实测的探头参数与两种仿真模型的结果对比,表明分布式传输线模型与实际情况更为吻合。
2.
Signal Quality of Dual-tip Electrical Conductivity Probe for Measurement of Bubble Parameters
双探针电导探头测量气泡参数的信号质量
3.
Strength Analysis of Screw Sufface and Structure Parameters Study of Auger of Mounted Hole Digger
挖坑机钻头螺旋面强度分析及结构参数探讨
4.
Preliminary Studys on Carotid Artery Parameters Detected by Intracavitary Convex Array Probe
腔内凸阵超声探头检测颈动脉参数的初步研究
5.
Research on improving related parameters of XBT based on quadratic fitting
利用二次拟合对XBT探头相关参数的改进
6.
Troubleshooting of Release Valve and Finger Probe for Multi-parameter Monitor
多参数监护仪放气阀、手指探头故障与维修
7.
Inverse determinations of the parameters of three-layered plate using angle probe generated Lamb waves
用斜探头激发的兰姆波对三层板参数进行反演测试研究
8.
Discussion on the Influencing Mechanism of the Cutting Parameters of Sugarcane Harvester to the Crash Rate of Cane Stubble
甘蔗收割机切割参数对甘蔗破头率的影响机理探讨
9.
Theoretical and Experimental Researches on Open-ended Coaxial Probe Measurement Techniques for Simultaneously Determining Complex EM-parameter;
开口同轴探头同时测量复电磁参数技术理论研究与实践
10.
Optimization of design and parameters of the ionization chamber for CSNS and PA beam loss monitor(BLM) system
CSNS和PA束流损失监控(BLM)系统电离室探头设计参数的优化
11.
The Influence of Dimensional Parameters of Linear Phased Array Transducer on Beam Directivity
超声相控线阵探头线列参数对波束指向性的影响
12.
Network Probes Provide In-Depth Data
网络探头提供深度数据
13.
Parameters Optimization and Improvement of Oxygen Lance Nozzle for Converter
转炉氧枪喷头工艺参数的优化与改进
14.
Hair Growth Parameters of Chinese Subjects in Spring and Autumn
春、秋季汉族人头发生长参数的评估
15.
Mechanical Parameter and Energy Model of Rotary Cutting Head Flying Shears
滚筒式切头飞剪力能参数与能量模型
16.
Parametric Modeling of the Basic Characteristics on Turning Joint based on UG NX4.0
基于UG基本特征的转接头参数化建模
17.
Calculation of Mechanical Parameters of 5-roll Peeling on Aluminum Strip Finishing Line
铝带精整机组五辊直头力能参数计算
18.
The distinction of the PDC bit balling and its features of mud logging parameters
PDC钻头泥包的识别及其录井参数特征