1.
To Apply on the Axle Model in the Risk Managing of Projects Cluster
轮轴模型在项目群风险管理中的应用
2.
Building the Steam Turbine Shafting Alignment Model by EXCEL
利用EXCEL软件建立汽轮机轴系找中模型
3.
Dynamic Simulation Study Based on Single Shaft Heavy-Duty Gas Turbine Model Using SIMULINK
基于SIMULINK的单轴重型燃气轮机模型动态仿真研究
4.
Acceptance test on model for Kaplan turbine in Xixiayuan Project
西霞院工程轴流转桨式水轮机模型验收试验
5.
Calculation of Heat Balance during Mold Filling for Hollow Camshaft in EPC
消失模铸造空心凸轮轴充型过程中热平衡计算
6.
Analysis on Mold Filling of Hollow Camshaft in EPC
气化模铸造空心凸轮轴的充型过程分析
7.
Derivation of Cutting Tool Axis Mathematics Model from the Gear-Grinding Machine s Cam-making;
Gleason №27磨齿机凸轮加工的刀具轴线数学模型
8.
Multi-axis Machining Oriented Researches of Turbine Blade Surface Modeling
面向多轴加工的汽轮机叶片型面建模技术研究
9.
Modeling and simulation of single shafe heavy-duty gas turbine using SIMULINK
基于SIMULNK的单轴重型燃气轮机建模与仿真研究
10.
Disk Low Cycle Fatigue Life Prediction Based on Multiaxial Fatigue Model
基于多轴疲劳模型的轮盘低循环疲劳寿命预测
11.
Pressure pulsation similarity relationship between model and prototype Kaplan turbines
轴流式原型和模型水轮机的压力脉动相似性分析
12.
Verify Crankshaft—Camshaft Installation—Typical
验证曲轴—凸轮轴安装—典型的
13.
Sand Care Making Technology and Mould Design for Cylinder Blolck and Camshaft of Model 491 Engine
491型发动机缸体、凸轮轴砂芯制芯工艺及模具设计
14.
Study on the Kinetic Mathematical Model of Normalization in Ductile Iron and Optimization of Process;
球铁凸轮轴正火动力学数学模型研究及其工艺优化
15.
Investigation on Analysis and Control to 300MW Turbogenerator Rotor Shafting by Computer Aided Engineering;
利用CAE技术对300MW汽轮机转子轴系实验模型分析与控制的研究
16.
Constitutive Model for Non-Proportionally Multiaxial Time-Dependent Ratcheting of 304 Stainless Steel
304不锈钢非比例多轴时间相关棘轮行为的本构模型研究
17.
The elastic deformation of the transmission shaft and the bearing, the drive of the mesh toughness, error and mesh impact were considered in the model.
模型中考虑了传动轴和轴承的弹性变形以及齿轮的啮合刚度激励、误差激励和啮合冲击激励。
18.
Research on Net-based Modeling of Axial Pump s Impeller and Pump Shaft s Virtual Machining;
轴流泵叶轮网络化建模与泵轴虚拟加工的研究