1.
The Optimized Research of Technics on Super-large Thickness Machining Technology of WEDM
超大厚度电火花线切割工艺优化研究
2.
Research on Super-large Thickness Machining Technology of WEDM;
电火花线切割超大厚度切割技术的研究
3.
Study and Practice of Vibroroller Compaction in Large Thickness Cushion for Ground Treatment
振动碾压在超大厚度换填软弱层地基处理中的研究与实践
4.
Application of Multizone Ultrasonic Inspection for Great Thickness EBW
应用超声多区聚焦技术检测大厚度电子束焊缝
5.
tin leaf of a thickness not exceeding 0.2mm
锡片,厚度未超过0.2mm
6.
direct viewing type ultrasonic thickness gauge
直观式超声波厚度计
7.
millstone for pulping exceeding 1200mm in diameter and 500mm in thickness
捣碎磨石机,直径超过1200mm、厚度超过500
8.
maximum width and thickness of the pad
荚的最大宽度及厚度
9.
The aluminum sheets cannot be too much thicker than 0.04 inches.
铝板厚度不能超过0．04英寸。
10.
Critical Thickness Investigation of MgB_2 Superconductivity Multilayer Films;
MgB_2超导多层膜间临界厚度研究
11.
The Primary Measurement Study of Ultrasonics on Skin Thickness in Children;
儿童皮肤厚度的超声学初步测量研究
12.
Insulation thickness, sheath thickness and maximum overall diameter.
补偿导线的线芯绝缘厚度，护套厚度及最大外径。
13.
Correlation Analysis between Prehepatic Fat Thickness and Visceral Fat Thickness by Ultrasonography
超声检测女性肝前脂肪厚度与内脏脂肪厚度的相关性研究
14.
Discuss lightly the welding technology of P91+12Cr1MoVG on extra-thick wall big diameter pipe dissimilar steel
P91+12Cr1MoV异种钢超厚壁大径管焊接工艺
15.
Construction Technology of Ultra-thick Mass Concrete Slab in Century Display Project
深超光电底板超厚大体积混凝土施工技术
16.
Optical properties of thin vapor layers are strongly affected by the influence of the boundaries.
通过数值分析研究了超薄气体的透射与反射光谱特性与其厚度大小的对应关系。
17.
when the thickness measurer detects a certain exceeding standard thickness, corresponding screws in die lips will act in response to result in effective adjustment and control of thickness
当厚度测量仪检测到某处超过标准厚度, 模唇上相应的螺丝会自动反应,有效地调节和控制厚度
18.
Evaluation of Uncertainty in Ultrasonic Measurement of Wall Thickness of In-use Oil Well Tubing
在役油井管壁厚度超声波测量不确定度的评估