1.
Application of combined dies in automobile production
冲压单元组合模具在汽车生产中的应用
2.
Rigid Element Analysis for Stamping Springback Simulation;
冲压成形回弹仿真的刚性单元法研究
3.
Study on extrusion and exhaust process of monopropellant pulse thruster
单组元脉冲推力器挤压和排气过程分析
4.
Research on the Stamping Direction、Element Model and Relaxation Factor in One Step Simulation
一步模拟中冲压方向、单元模型及松驰因子算法研究
5.
vertical straight side single action presses
立式单动直边冲压机
6.
stroke-controlled single column straightening press
单柱可控冲程压直机
7.
Weld identification single hole punch.
鉴别焊缝的单孔冲压机
8.
OIL PRESSURE SENDING UNIT CONNECTOR
油压开关传送单元接头
9.
Macro-Model of Single-Electron Transistor Based on Voltage-Controlled Unit
基于压控单元的单电子晶体管宏模型
10.
A nonlinear FEM analysis of piston for a hydraulic drill-rod
液压冲击器活塞的非线性有限元分析
11.
Pressed Loose Steel Pipe Flanges and Their Finite Element Analysis
冲压松套钢制管法兰及其有限元分析
12.
Fast stamping FEM analysis of automotive sheet metal based on Abaqus software
基于Abaqus的汽车板快速冲压有限元分析
13.
Magnetic Component Design and Circuit Simulation for MPC System
磁脉冲压缩系统元件参数及电路仿真
14.
single-acting turbocharged two-stroke engine
单作用增压式二冲程发动机
15.
The Research of Pilot-operated Check Valve With Slow Impulse for Hydramatic Supports
液压支架用缓冲式液控单向阀的研究
16.
obtained the formed punch unit pressure distribution situation and how the pressure change with stroke;
得到了冲头的单位压力分布及冲头压力随行程的变化情况;
17.
RECONNECT THE HYDRAULIC CONTROL UNIT 6-WAY CONNECTOR.
重新连接液压控制单元６路接头
18.
Hydraulic power modules imported from Europe and USA.
油压动力单元选用欧美进口之零组件。