1.
These events were referred to as ground roll.
那些同相轴称为地滚波。
2.
Of, relating to, or serving as a pivot.
枢轴的枢轴的、与枢轴相关的或作为枢轴的
3.
These are the same as those used for the main bearings.
这些轴承与那些被用作主要轴承的轴承相同。
4.
photographic film wound on a spool.
缠在线轴上的照相软片。
5.
Specification: direction of rotation of output shaft varies with that of input shaft.
说明：当输入轴旋转方向改变，输出轴相应改变。
6.
An engine shaft fitted with a cam or cams.
凸轮轴与一个或多个凸轮相配的机器轴
7.
Experimental Research on Oil-Air Two Phase Lubrication of High Speed Motorized Spindle Rolling Bearing;
高速电主轴滚动轴承油气两相流润滑试验研究
8.
The calculation and balance of the axial force of borehole helico-axial multi-phase pump
井下螺旋轴流式多相混抽泵轴向力计算及平衡
9.
3-D Column. Compares values across categories and across series
三维柱形图。比较相交于类别轴和相交于系列轴的数值
10.
Of or being a crystal system of three equal axes lying at right angles to each other.
等轴晶的由三根相等的轴彼此以直角相交构成的晶体系统的
11.
"If the bearings seem to have worn fairly uniformly, then the chances are that only crankshaft-journal checks and bearing replacement will be required."
如果轴承看上去似乎已磨损的相当均匀,那么只需要检查曲轴轴颈并更换轴承。
12.
"When the two shafts are at an angle to each other, the bearings in the yokes permit the yokes to swing around on the trunnions with each revolution."
当两轴相互处在同一角度上,主动轴转动时万向节叉上的轴承使万向节叉绕万向节十字轴摆动。
13.
There was slight axial rotation of the tibia relative to the femur.
相对于股骨,胫骨出现轻微轴向转动。
14.
Bevel gears: gears which connect two shafts at right angles.
伞齿轮:连接直角相交两轴的齿轮。
15.
the point of intersection of coordinate axes; where the values of the coordinates are all zero.
坐标轴的交叉点，所有相应值都为零。
16.
external phasing gears
(单纯旋转发动机的) 外轴式相位机构
17.
Knife shaft can be360 degree adjusted by electric control.
刀轴可做360度电动控制相位调整。
18.
one of two points of intersection of the Earth's axis and the celestial sphere.
地轴延线与天球相交的两点之一。