1.
FEM Analysis on Warm Extrusion Concave Die of Drilling Bit Shell
凿岩钎头壳体温挤压凹模的有限元分析
2.
Failure Mechanism Analysis of the Cold Extrusion Combination Concave Die and Numerical Simulation of the Extrusion Process
冷挤压组合凹模失效分析及挤压过程数值模拟
3.
A Study on Optimal Design Method for the Die of Forward Heat Extrusion
正向热挤压凹模优化设计方法的研究
4.
Finite Element Analysis of Forward Extrusion Cavity Die for Deep Hole and Thin Wall Shell
深孔薄壁件正挤压凹模的有限元分析
5.
Finite Element Simulation of Internal Pressure of Backward-Extruding Containers and Optimization of Combined-Containers;
反挤压凹模内压力的有限元模拟及组合凹模优化
6.
An Investigation on Structure of Extrusion Die and Optimization of Combined Dies about Support Shaft with Finite Element Method;
支撑轴挤压模具有限元分析及组合凹模优化
7.
Numerical Simulation of the Spur Gear Extrusion Shaping Under Different Forms of Dies
不同凹模形式下直齿轮挤压成形数值模拟研究
8.
Analysis of Upper Bound Solution in Conmcal Die for Extrusion/Drawing Processes
锥形凹模内挤压/拉拔过程的上限解分析
9.
Synthetical Analysis of Extrusion Die Strength by FEM-Optimum and Photoelastic Method
挤压凹模强度的光弹性与有限元优化综合分析
10.
Structural Optimization Design of Cold Extrusion Die Based on Small Elastic-plastic Deformation
基于小弹塑性变形的冷挤压凹模结构优化设计
11.
a concavity in a surface produced by pressing.
由于挤压而形成的凹陷。
12.
New upper bound model for extrusion/drawing processes through conical die
适用于分析锥形凹模内挤压/拉拔过程的新的上限模型
13.
Cold Extrusion Process for Involute Spline Part and Concave Die Optimize Design Based on Numerical Simulation;
基于数值模拟的渐开线花键件冷挤压工艺及凹模优化设计
14.
FE Analysis of Composed Dies Stress in Cold Extrusion Process and Study on Fatigue Life of Dies;
冷挤压组合凹模的应力场数值模拟及疲劳寿命估算研究
15.
Research on Rectangle Spline Cold Extrusion Process and Optimizing Design of Multi-Layer Composite Concave Die;
矩形花键冷挤压工艺研究及组合凹模的优化设计
16.
Numerical Simulation of Fluid-Solid Coupling for Lubricating Oil Extrusion Process Between Cylinder and Piston with Micro-pits
凹坑表面活塞与缸套挤压润滑油的流固耦合数值模拟
17.
Numerical Simulation and Procesee Investigation on Non-Isohtermal Extrusion of TC4 Cup-Shape Part;
TC4杯形件非等温挤压过程数值模拟及工艺研究
18.
A Technique of Isothermal Extrusion Pre-forming and Optimization of Mould Structure for Globoidal Indexing Cams Parts;
弧面凸轮等温挤压预成形工艺与模具结构优化