1.
Finite element model for brick masonry wall reinforced with FRP under in-plane loading
FRP增强砖砌体墙在平面内荷载作用下有限元模型
2.
INTERNAL FORCE ANALYSIS AND SIMPLIFIED CALCULATION OF CURVE BEAM UNDER UNIFORM LOAD;
均布荷载下平面弧形梁内力分析与简化计算
3.
RESEARCH ON IN-PLANE STABILITY BEARING CAPACITY OF LIPPED H-SECTION TAPERED MEMBERS UNDER COMPRESSION AND BENDING
卷边翼缘工形变截面构件在压弯荷载作用下平面内稳定承载性能研究
4.
Research on the Relationship between Pavement Evenness and Vehicle Dynamic Load;
路面平整度与车辆动荷载关系的研究
5.
To verify the theory, these stress formulae are simplified to those for the beams with longitudinal symmetrical plane and loaded in the plane.
作为特例,也可以从上述公式得到该梁在具有纵向对称面,且载荷作用在该平面内时的相应公式。
6.
Safety Assessment of Metal Structure with Surface Plane Defects under Random Loads
随机载荷下含表面平面缺陷结构的安全评定
7.
Estimation of Ultimate Resistant Capacity of Non-Symmetric Planar Steel Frame Structures under Horizontal Load
平面非对称钢框架结构在水平荷载下的极限承载力估计
8.
Experimental Investigation on Turbulence Modification in a Horizontal Channel at Relatively Low Mass Loadings;
水平槽道内低颗粒载荷下湍流变动的实验研究
9.
Study on Load Mode of Road Tunnel with Extra-large Cross-section and Low Flat-ratio and Its Application;
扁平特大断面公路隧道荷载模式及应用研究
10.
Calculation of earth load on landslide retaining structure based on planar sliding
从平面滑动思考滑坡支挡结构荷载计算
11.
Maneuver Load Optimal Distribution Between Canard and Horizontal Tail of Three-surface Aircraft
三翼面飞机前翼和平尾机动载荷优化配置
12.
Stability Analysis of Ship Structures under in-plane Loading;
面内荷载作用下船体结构的稳定性分析
13.
Stress pulse durations in asphalt pavement under moving load
移动荷载下沥青路面内应力脉冲的持续时间
14.
Study of plastic limit load of the combined fittings of double elbows under in-plane bending moment
面内弯矩下双弯头组合管件的极限载荷研究
15.
Research on In-plane Ultimate Bearing Strength of Tapered Column;
楔形变截面柱平面内稳定承载力研究
16.
irregularly distributed load
非匀布荷载;不规则分布荷载;不均匀分布荷载;不平匀分布荷重
17.
Study of Bounding Surface Model for Monotonously and Cyclic Loading on Bias Plane for Concrete
偏平面上单调及循环荷载作用下混凝土的边界面模型研究
18.
To increase the contact area and permit larger loads to be carried, the balls run in curvilinear grooves in the rings.
为了增加接触面积并承受较大载荷,滚珠在内外环的曲线槽内滚动。