1.
A Brief Introduction of How to Improve the Cycle Turning Command of Numerical Control Lathe
浅谈GSK928TA数控车床循环车削指令的改进
2.
The Application Skills of Sole and Cycling Instructions in NC Lathe Machining
数控车削固定循环指令和单一指令的应用技巧
3.
Research on Comparison and Application of Cycling Instructions for Turning of NC Lathe
FANUC系统中车削循环指令比较与应用研究
4.
Some applied technologies in editting NC lathe programs;
数控车床加工中循环指令编程设计技巧
5.
The Application of Mastercam X in the Cycle Instructions of FANUC 0i-TB CNC Turning System
Mastercam X在FANUC 0i-TB系统粗、精车循环指令中的应用
6.
ID Instruction Decoder. This unit is capable of decoding up to3 instructions per cycle.
命令解码。本单元每循环能解三条指令。
7.
Application in the Post-processing for Command in Huazhong NC Lathe Systems Based on MasterCAM9.1
基于MasterCAM9.1的华中数控车削指令后处理的应用
8.
Study on Cylinder Milling CAM System of Turning Center Based on Cylinder Interpolation;
基于圆柱插补指令的车削中心柱面铣削CAM模块的研究
9.
Loop: Series of computer instructions repeated until a condition is reached which diverts from the loop.
循环:重复执行的一串电脑指令，直到预定条件满足时，然后脱离循环。
10.
This loop consists of3 instructions also with unknown sum of latency.
这个循环由三条指令组成，也不知道潜伏期的和。
11.
Analysis Characteristics of Programming and Techniques of Canned Cycle Numerical Control Functions;
固定循环数控指令的编程特点及工艺分析
12.
The Study of Compound Canned Cycle Code about the System ofFANUC-OTDII;
FANUC-OTDⅡ系统复合型固定循环指令的应用探讨
13.
The Development of Cycling Program for Processing End-face Deep Hole Based on HNC-21/22T
基于HNC-21/22T端面深孔加工循环指令的开发
14.
Is batching of small orders routinely done; that is, are blanket purchase orders of commonly used low unit cost items provided?
对于常用、低单价项目的综合采购指令，是否提供循环使用的小批量采购指令？
15.
Research on Fixed Repeating Instructions in Open Architecture CNC System and Arithmetic of 5-Axis Tool Compensation;
开放式数控系统固定循环指令及五轴刀补算法的研究
16.
Application of Macro-program Designing Milling-circulation on FANUC Systen;
在FANUC系统上开发铣削循环宏程序
17.
Metacyclic Groups with a Cyclic Subgroup of Index 2
具有指数为2的循环子群的亚循环群
18.
trolley recirculation system
行李手推车循环系统