1.
The rotor connected the various ports in the stainless-steel valve block.
转动件和不锈钢阀块各个孔相连。
2.
Application of Finite Element Analysis on the Valve Block Design
有限元分析在液压阀块设计中的应用
3.
Application of the Pro/E in Hydraulic Valve Block Design
Pro/E配合件设计在液压阀块设计中的应用
4.
To replace the seat module, pull the seat module out of the body by gripping at the reinforcement ring.
为了更换阀座模块，抓住加强环，将阀座模块拉出阀体。
5.
Reassemble the check module in the reverse order. Install the check modules into the valve body hand-tight. Replace the cover.
按照相反顺序重新组装止回阀模块。将止回阀模块安装进阀体内，用手紧固。重新安装阀盖。
6.
Check modules are installed in the valve body with the seats facing the valve inlet.
安装在阀门内的止回模块其阀座应该面对阀门进口。
7.
Marine male threaded weight quick-closing valves
GB/T1850-1984船用外螺纹重块式快关阀
8.
The Modular Modeling and Research of Valve Controlling Cylinder Based on MATLAB/SIMULINK
基于MATLAB/SIMULINK的阀控缸模块化建模与研究
9.
Design of Magnetic Valve Controller Based on GSM Model
基于GSM模块的电磁阀控制器设计
10.
Remove first check module from module adaptor, and repeat above procedure with second check module.
从模块适配器上拆卸第一止回阀模块，对于第二止回阀模块重复上列步骤。
11.
Lift the check valve module straight out taking care not to hit and damage the seating.
笔直地将止回阀模块提起，要注意不要撞击和损坏阀座密封。
12.
The disc can be cleaned without disassembly or the relief valve module.
阀瓣可以在不拆卸安全阀模块的情况下进行清洗。
13.
The check valves shall be modular and shall seal to the main valve body by the use of an O-ring.
止回阀应该是模块化，并通过一个O形环密封连接到主阀体上。
14.
Remove the retainer from the body bore. The check valve modules can now be removed from the valve by hand or with a screwdriver.
从阀体镗孔上拆卸保持器。现在可以用手或螺丝刀从阀体上拆卸止回阀模块。
15.
The assembly shall consist of two threaded-in check modules with captured springs and silicone seat discs.
这种总成应该由两个螺纹旋进、配置复位弹簧和硅酮阀座阀瓣的止回阀模块构成。
16.
Development of EPA High Speed Communication Module for Intelligent Valve Positioner
智能阀门定位器EPA高速通信模块的开发
17.
Fast motion estimation research of adaptive threshold static block detection
自适应阀值静止块检测的快速运动估计研究
18.
Dual voltage driver module for solenoid valve in common rail injector
共轨喷油器电磁阀双电压式驱动模块设计