1.
Common problems and solutions in grabbing beam of the gate hoist at hydropower station
电站闸门启闭机抓梁系统常见问题及解决方法
2.
On Gate Hoist Girder Construction Stent Design of Jinyintai Navigation and Hydropower Project
金银台航电枢纽闸门启闭机主梁施工支架设计
3.
Design of Drop-tilting Gates at Dahua Hydropower Station and the Layout of Hoist
大化水电站船闸卧倒闸门设计及启闭机布置
4.
Hydraulic Synchronization System about Two Lifting Point Gate;
双吊点闸门液压启闭机同步系统概述
5.
Supervision on Installations of Gates and Hoists in te Bid Ⅱ Project at the Ertan Hydropower
二滩水电站Ⅱ标工程闸门与启闭机的安装监理
6.
Research on Safety Evaluation of the On-active Service Sluices and Hoists;
在役水利水工闸门与启闭机的安全评价
7.
Analysis of the hydraulic synchronous lifting system for two lifting-point hydraulic hoist
闸门双吊点液压启闭机液压同步系统分析
8.
Real time defect diagnosis and protection for hoist system of sluice based on CS5463
基于CS5463的闸门卷扬启闭机实时诊断和保护
9.
Probe into Reconstruction of Rod Seal Device of Intake Gate Hydraulic Hoist in Ankang Hydropower Plant
安康水电厂快速闸门启闭机活塞杆密封改造
10.
Dynamic simulation research on miter gate operating machine based on virtual prototype technology
基于虚拟样机的人字闸门启闭机动力学仿真分析
11.
Study on Net Hydrodynamic Hoist Load Characteristics of High Head Lock Culvert Valves;
高水头船闸输水阀门净动水启闭力特性研究
12.
APPLICATION OF TECHNOLOGY OF PLANTING REINFORCING BAR ON RECONSTRUCTION OF ON-OFF MOTOR ROOM OF SANHE FLOOD GATE
植筋技术在三河闸启闭机房改造中的应用
13.
Physical Model Study on the Dynamic Loads and Flow-induced Vibration of Emergency Sluice Gate in Xiluodu Tunnel Spillway;
溪洛渡水电站泄洪洞事故闸门启闭力及流激振动试验研究
14.
The 3D Numerical Simulation Study on High Head Lock Valves Opening and Closing Process and Pattern Optimization
高水头船闸阀门启闭过程及体型优化三维数值模拟研究
15.
Study on the Remote Monitoring and Control System for Double-suspension Sluice Hydraulic Hoist Based on Internet;
基于Internet的双吊点水闸液压启闭机远程监控系统研究
16.
Design and application of hydraulic hoisting gear following the principle of standardization,serialization and universalization in Jiangsu province
江苏省船闸液压启闭机的“标准化、系列化、通用化”设计和应用
17.
For the following valves with HIS option the center to top dimensions( open and closed) must be increased approximately2 inches, consult factory for exact dimensions.
对于拼合楔形闸板阀门的中心线至顶端(启和关闭状态下)尺寸，请咨询工厂。
18.
Dynamic Simulation of Gantry Hoist Based on Virtual Prototyping Technology;
基于虚拟样机的门式启闭机动力学仿真研究