1.
Simulation in the Process of Electrolytic Grinding of the Low Rigidity, Variable Cross-section Shaft;
低刚度、变截面轴电解磨削加工仿真技术
2.
Simulation in the Process of Electrolytic Grinding of the Low Rigidity,Variable Cross-section Shaft Based on CATIA
基于CATIA的低刚度、变截面轴电解磨削加工仿真
3.
Studies on Stability Behavior and Design Method of Shuttle-Shaped Axially Loaded Column;
梭形变截面轴心受压柱的稳定性能与设计方法研究
4.
CALCULATION OF SHEARING STRESS FOR AXIAL DRAWING OF TRANSFORM SECTION BAR
变截面直杆轴向拉伸时的剪应力计算
5.
perpendicular cut
(与轴成)垂直(截面)截割
6.
CALCULATION OF CRITICAL BUCKLING LOAD OF VARIABLE CROSS-SECTION ELASTIC COLUMNS UNDER AXIAL VARYING COMPRCSSIVE LOAD BY BEM
用边界元法计算变截面变轴力柱的屈曲
7.
Nonlinear Analysis of R/C Sections Subjected to Varying Axial Forces;
考虑变化轴力的钢筋混凝土截面非线性分析
8.
Study of the Inner Boundary Force of Axial Variable Cross Section Annulus Power Law Fluid
轴向变截面环空幂律流体内边界力的研究
9.
Experimental and Theoretical Study on Distortional Buckling of High Strength Cold-formed Steel Lipped Channel Columns under Axial Compression;
高强冷弯薄壁型钢卷边槽形截面轴压柱畸变屈曲试验与理论研究
10.
Calculation of Bearing Capacity of Axial Compression Short Column with Round Cross-Section Reinforced by Enlarging Cross-Section Method
扩大截面加固轴心受压圆截面短柱承载力计算
11.
A Study on the Walk-Off Angle in the Optical Indicatrix s Principal Section of Uniaxial Crystal;
单轴晶光率体主截面内离散角的研究
12.
Effect of axial compression ratio to bearing capacity of piece with T-shaped section
轴压比对T形截面构件承载力的影响
13.
Manufacture Process Optimization of C45 Screw Shaft Forgings with Great Section
大截面C45艉轴锻件制造工艺优化
14.
piston-type variable area flowmeter
活塞式变截面流量计
15.
iable area flowmeter
活塞式可变截面流量计
16.
" Reflecting prisms--Optical axis, length of opticalaxis, axial section and optical parallelism"
GB/T7660.1-1987反射棱镜光轴、光轴长度、光轴截面与光学平行度
17.
Function Analysis of Short-Round Bridge Pillar under Axial Loading Reforced by Enlarging Section;
扩大截面加固轴心受压圆截面短桥柱受力性能分析
18.
The circle section is rather reasonable for axial compressed member.
在轴向受压构件中,用圆形截面也是合理的。