1.
Design of angle conversion experiment equipment of double channels based on C8051F021
基于C8051F021的双通道轴角测量实验装置的设计
2.
The angle measurement system based on inductosyn and the analysis of its error
基于感应同步器的轴角测量系统及其误差分析
3.
Angle Measurement System Based on Inductosyn and its Application
基于感应同步器的轴角测量系统及应用
4.
Measurement System of Synchro's Shaft Angle Signal Based on TMS320LF2407
采用TMS320LF2407的自整角机轴角信号测量系统
5.
This measurement will give you the propeller shaft angle (C).
测量结果就是传动轴工作角（c）。
6.
Precise Joint Angle Measurement System for Direct Drive Robot
直接驱动机器人轴角的精密测量系统
7.
J6928 Measurement Instrument for Contact Angular of Bearings
J6928轴承接触角测量仪的开发
8.
Azimuth, in Ellipsometry- The angle measured between the plane of incidence and the major axis of the ellipse.
椭圆方位角-测量入射面和主晶轴之间的角度。
9.
Comparative Estimation of Axial Length and Keratometric Power Measured by IOLMaster、Contact Ultrasound A-scan and Keratometer
IOLMaster测量眼球轴长和角膜曲率与A超和角膜曲率计测量的相关性研究
10.
A reference line from which distances or angles are measured in a coordinate system.
座标轴坐标系中测量距离和角的参考线
11.
Development on Friction Torque Meter for Paired Angular Contact Ball Bearings;
成对角接触球轴承摩擦力矩测量仪研制
12.
Mathematic Model of Axis Deviation Influence on Surveying Angle and Its Correction;
轴系偏差对测量角影响的数学模型及改正方法
13.
Design of Indirect Measuring Tool used to Angle Error of Shaft Part
轴类零件角度误差间接测量检具的设计
14.
A Method to Measure Vertical Axis Roll Angular Errors of Machine Tool Based on Laser Interferometer
基于激光干涉仪的垂直轴滚转角误差测量方法
15.
Angular momentum is an axial vector quantity.
角动量是一种轴矢量。
16.
axonometric(al) drawing
轴测图，不等角投影图
17.
The measurement of angle error on load mechanism of dynamic and externally pressuried air bearing test stand
气体动静压轴承实验台加载装置误差角度的测量
18.
Improvement of measuring method of contact point groove diameter for double-direction thrust angular contact ball bearing
双向推力角接触球轴承接触点沟径尺寸测量方法的改进