1.
Application of Offset Mechanism of Crankshaft in Rolling-type Heavy Steel Shear
曲轴偏置机构原理在钢板滚切剪机设计中的应用
2.
The crank is an offset section of the crankshaft.
曲柄是曲轴的偏置部分。
3.
spiral bevel gears with offset axes
轴线偏置螺旋伞齿轮
4.
closed crankcase ventilating system
闭式曲轴箱通风装置
5.
Crankshaft Journal Size Paint Location
曲轴颈部尺寸标记位置
6.
Crank Position Sensor Sig
曲轴位置感知器信号
7.
Research on the H_∞ Control System in the Radial-Axial Magnetic Bearing Biased with Permanent Magnets;
永磁偏置径向轴向磁轴承H_∞控制系统的研究
8.
Design and Realization of Control System for the Radial-Axial Direction Magnetic Bearing of Permanent Magnet;
永磁偏置径向-轴向磁轴承控制系统设计与实现
9.
A New Permanent Magnet Biased Radial Magnetic Bearing
一种新型结构的永磁偏置径向磁轴承
10.
Research Status and Development of Permanent Magnet Biased Magnetic Bearings
永磁偏置磁轴承的研究现状及其发展
11.
The Causes of Crankshaft Offset Grinding and Grinding Crack and Their Solutions;
曲轴偏磨与磨削裂纹的成因及解决办法
12.
Unbiased Crank and Rocker Mechanism with 90° Tilt Angle and Its Application
90°摆角无偏置曲柄摇杆机构及其应用
13.
Failure analysis of upset-bending equipment for a heavy crankshaft with continuous grain flow
大型全纤维曲轴TR镦锻装置失效分析
14.
"because an eccentric can be attached anywhere along a shaft, it is unnecessary to form any part of the shaft into a crank."
由于偏心轮可装于轴的任何部位,不必把主轴作成曲柄。
15.
The design of a support with eccentricity for turning high-power 9 cylinders diesel engine crank pin
大型9缸柴油机曲轴连杆轴颈车削偏心扶架设计
16.
Method of Estimating In-plane Shear S-N Curve of Unidirectional Laminate from Off-axis Tension S -N Curve
由单向层压板偏轴拉伸S-N曲线估算面内剪切S-N曲线的方法
17.
Study on Permanent Magnet Biased Magnetic Bearing and Its Control Method;
永磁偏置混合式磁轴承及其控制方法的研究
18.
Combined Control for Three-axis Stabilization of Micro-satellite Using Thrusters and Single Pitch Bias Momentum Wheel
喷气/偏置动量轮联合微小卫星三轴稳定控制