1.
Changing of Forging Process and Increasing of Ultrasonic Inspection Qualification Rate for GH2036 Turbine Disk
GH2036涡轮盘锻造工艺的改变与探伤合格率的提高
2.
Effect of Rough Rolling Schedule of Plate 16MnR on Passing Rate of Detection
粗轧区变形量对16MnR钢板探伤合格率的影响分析
3.
Research of the relationship between the sulfur content in steel and the flaw detection eligibility rate
钢中硫含量与钢板探伤合格率关系的调研
4.
Analysis of Unqualified Cause of Thick Gauge High Strength Steel Plate in Ultrasonic Flaw Detection
厚规格高强度钢板探伤不合原因分析
5.
436 the welds passed the examination of radiographic test (ultrasonic inspection, magnetic testing).
这焊缝通过射线透视检查（超声波探伤、磁力探伤）合格。
6.
Analysis of Causes for Ultrasonic Test Defects in Z-Direction Steel Plate
Z向钢板超声波探伤不合格的原因分析
7.
The welds passed the examination of radiographic test( ultrasonic inspection, magnetic testing).
这焊缝通过射线透视检查（声波探伤、力探伤）格。
8.
Coverage of qualified iodized salt at household leve
居民合格碘盐使用率
9.
lot tolerance percent defective
批容限不合格产品率
10.
Ф177.8 mm Steel Pipe United Crack Inspected Product Line
Ф177.8mm钢管联合探伤生产线
11.
Probe into evaluation of trade discrimination rate of occupational injury insurance;
工伤保险行业差别费率确定方法探讨
12.
Research on the Principle Factors in Strength & the Damage Mechanical Model of the Cement-lime-loess and Probability Analysis of the Bearing Capacity of Lime Soil Compaction Pile Composite Foundation;
水泥灰土强度影响因素及其力学损伤模型初探与灰土挤密桩复合地基承载力的概率分析
13.
Research on Position Disposition and Damage Probability of Artillery Company in Joint Fire Damage
联合火力毁伤下炮兵连阵地配置与被毁伤概率
14.
Fermented bean curd antiseptic 100% qualified, dried vegetables benzoic acid qualified rate 98.04%.
腐乳防腐剂100%合格，于菜苯甲酸合格率98.04%。
15.
Comprehensive Measures for Improvement of Voltage Qualification Rate for 10kV Feeder
提高10kV馈线电压合格率的综合措施
16.
Result: The results indicated that the eligibility rate of hands and air were 98.65% and 99.71%, respectively.
结果：采血人员的手合格率为98.65%，采血环境空气卫生合格率为99.71%。
17.
Exploration and Study on Premium Rate of Casualty Insurance for Occupational Injury in Anshan Iron and Steel Corporation;
鞍钢工伤保险基金收缴费率的探讨与研究
18.
Study on Optimum Frequency for Eddy Current Testing of Tubes by Numerical Modeling and Experimental Verification
管材涡流探伤最佳频率数值模拟与试验验证