1.
Implementation of Control & Protection Circuit for an Air-borne Radar Transmitter
机载雷达发射机控制保护电路的实现
2.
The Development of Current Protection Controller in 10kV Lines;
10kV配电线路电流保护控制器的研制
3.
A Study on Safeguard Circuit of Array Panel Power Supply for Phased Array Radar
相控阵雷达阵面电源保护电路的研制
4.
The charger adopts chip controlled charging, with constant current and constan charging, overcharge protection, short circuit protection and indications for charging status.
充电器采用芯片控制充电，具有恒流充电、充保护、路保护、电状态指示。
5.
Analysis of the Problems Related to Electrical Design of Motor Protection and Control Loop
电动机保护与控制回路电气设计有关问题分析
6.
The voltage of the analog signals in control and protection circuits are all below DC 24V.
控制和保护回路模拟信号的电压都低于24V直流。
7.
Research and Development of the Distributed Power Line Protection & Monitoring Device Based on DSP;
基于DSP的配电线路微机保护和测控装置的研制
8.
Research and Manufacture of New Transmission Line and Capacitor Protection Devices Integrated with Measurement and Control;
线路及电容器新型测控保护装置的研制
9.
Analysis on Series Compensation System Bypass due to Power Fault of Progammable Logic Controller
串补控制保护PLC电源故障导致串补旁路的分析
10.
Power control Box supply stable voltage and current overload, over voltage protected.
整合电源控制盒提供稳定电压、电流保护、电压保护，线材安装以星状网路线路安装方式。
11.
The composition of the inverter, the working principle of full-bridge main circuit, controlling circuit, drive circuit and protect circuit are described.
就其电源的主体结构，全桥主电路、控制电路、驱动电路以及保护电路的工作原理作了简要的论述。
12.
The Design of Power-Fail Protection Circuit in Thickness-Stacked Stamping Control System of MotorIron-Core with Skewed Slot
电机铁芯扭槽叠扣冲压控制系统掉电保护电路的设计
13.
The charger adopts chip controlled charging,with constant current and constan charging,overcharge protection,short circuit protection and indications for charging status.
充电器采用芯片控制充电，具有恒流充电、过充保护、短路保护、充电状态指示。
14.
The Research on Over-Voltage and Protection & Control System for UHV Transmission Line;
特高压输电线路过电压及保护与控制系统的研究
15.
The Research of Amplifier and Relative Protection Circuit in Power Switch Supply Control Chip;
开关电源控制芯片中运算放大器及相关保护电路的研究
16.
According to the power supply protection request of a complex device, and a related control circuit is formed when a current is measured.
结合复杂设备中电源保护电路的要求,提出了检测电流时相关控制电路。
17.
Series of basic dimensions of control and protective panels and cabinet for secondary circuit of power system
GB/T7267-1987电力系统二次回路控制、保护屏及柜基本尺寸系列
18.
The Control of Crosstalk and Impedance Math-model based on PCB's Ground Track
电路板上地保护走线的阻抗数学模型和串扰控制