1.
Different items for different demand.
可根据不同温度要求选择适用不同温度的型号。
2.
"Different insulation materials such as refractory, refractory castable and fiber insulation materials are used in different zones."
炉子的保温材料根据炉子温度要求不同,分别选用耐火砖,耐火浇注料,纤维保温材料。
3.
Does the product Temperature Profile fall within the Engineering based specification for glass transition temperature requirements?
产品温度曲线是否降落到基于工程的玻璃转换温度要求的工程标准?
4.
Material limitations, restrictions, and special requirements are shown on pressure-temperature tables.
材料的局限、制和特殊要求，在压力-温度表中体现。
5.
Technical requirements and testing methods for temperature and humidity instruments for cargo hold of vessel
GB/T15309-1994船舶货舱温湿度仪技术要求及试验方法
6.
Also the machine mold is up to the required temperature and is usually controlled by thermostat.
铸焊模具应达到所要求的温度而通常用恒温器控制。
7.
Calibration environments( laboratory room temperature and relative humidity) requirements are well defined and documented.
对校正环境(验室的温度和相对湿度)要求清析定义于指引档中.
8.
"Today, if you want to take the temperature of a hub, you go in using SNMP to get the request," Emanuel says.
Emanuel称：“（目前），如果你要测集线器的温度，你就要用SNMP协议来得到此请求。
9.
Further qualifications require that the two fluids be miscible and that the density difference be a function of differences in temperature.
另外的条件要求两种流体可以掺混起来，并要求两种流体的密度差是温度差。
10.
This paper stated the principle of temperature control in different stages of fermentation and the design requirements of automatic control system for fermentation temperature in conical fermentor.
该文论述了发酵各阶段温度控制机理及锥形罐发酵温度自动控制系统设计要求。
11.
This reduced temperature dependence permits a simplified drive circuit and reduces the need for temperature stabilization.
与温度的关系变得不密切，也就使驱动电路简化并减少对温度稳定的要求。
12.
The government has asked people to save power by setting their heating controls at15centigrade.
政府要求人民将暖气的温度固定在15C，以节省电力。
13.
Automatic electrical controls for household and similar use--Particular requirements for temperature sensing controls
GB14536.10-1996家用和类似用途电自动控制器温度敏感控制器的特殊要求
14.
Does the product Temperature Profile meet the reflow requirements for the SMT components according to the component manufactures?
产品的温度曲线是否符合零件制造商提供的SMT零件回流焊要求?
15.
Basic environmental testing procedures for radiation detectors--Temperature test
GB/T10263.2-1988辐射探测器环境试验基本要求与方法温度试验
16.
On Temperature and Humidity Environmental Conditions of Military Dangerous Materials in Container Transportation;
军用危险物资集装箱运输温—湿度环境条件及防护要求
17.
To meet this requirement, low-temperature chambers or furnaces are often built to provide the needed range of temperature.
为了适应这种要求，常常修建低温箱或加热炉来提供所需的温度范围。
18.
Due to its low activity in the cold and the necessity to wash modern fibers at lower temperature,researchers were looking for improvernents.
由于过硼酸钠在低温下活性较低 ,而现代的许多纤维要求较低的洗涤温度。