1.
RESEARCH ON LOCAL BUCKLING OF LIPPED H-SECTION MEMBERS
卷边翼缘工形截面构件的局部稳定性能
2.
LATERAL STABILITY BEHAVIOR OF LIPPED H-SECTION BEAMS SUBJECTED TO MOMENTS
卷边翼缘工形截面梁的稳定性能及设计方法
3.
COMPARISON OF STABILITY CAPACITY AND ECONOMIC PERFORMANCE BETWEEN LIPPED H-SECTION MEMBERS AND H-SECTION MEMBERS
卷边翼缘工形构件稳定性能及经济性能分析
4.
LOAD-CARRYING CAPACITY OF LIPPED H-SECTION MEMBERS UNDER AXIAL LOAD
卷边翼缘工形截面构件在轴心压力作用下的稳定承载力研究
5.
LIMIT STRENGTH OF LIPPED H-SECTION MEMBERS UNDER BOTH COMPRESSION AND BENDING
卷边翼缘工形构件在压弯荷载作用下的稳定承载力设计理论
6.
RESEARCH ON IN-PLANE STABILITY BEARING CAPACITY OF LIPPED H-SECTION TAPERED MEMBERS UNDER COMPRESSION AND BENDING
卷边翼缘工形变截面构件在压弯荷载作用下平面内稳定承载性能研究
7.
Leaves curled, ragged edges.
叶卷曲、边缘破碎。
8.
The flames licked the sides of the fireplace.
火焰卷烧着壁炉边缘。
9.
one of the main flight feathers projecting along the outer edge of a bird's wing.
突出在鸟翼外边缘的一种主要的飞羽。
10.
The front wing was hanging off and the right rear tyre was off the rim.
前翼掉了下来，右后轮胎濒临爆胎边缘。
11.
Side of Al/Ni strip/plate should be even cut without burr.
镍铜带/片边缘应切齐，无毛刺（小于0.05㎜）、裂边和卷边。
12.
Leading edge and trailing edge means the function of the dimmer.
飞机螺旋桨的前边缘和机翼后边缘是最能够反应调光器的功能的。
13.
A projecting rim or lip, as on a pneumatic tire.
轮胎卷边突出的外围或边缘，如充气轮胎的边缘突起
14.
The hemming method most frequently utilized in the sample room is the plain hem stitch.
样品室使用最频繁的卷边针法是包缝缘边针迹。
15.
The edge of the fabric is rolled over the machine stitching to the wrong side and finished with a plain hem stitch.
布边卷过机缝线迹到反面,用包缝缘边针迹完成。
16.
Ulcer edge appears to" roll over" into the defect and is a tough fibrinous ring.
溃疡边缘“翻卷”进入凹陷处，形成一坚硬的纤维环。
17.
the edge of both flaps was rolled up and the posterior flap was turned up into a "hook" or "barrette".
裂孔边缘特别是后瓣多翻卷形成钩状或发夹状。
18.
Having the edges folded or turned inward.
（幼叶等）镊合内曲状的边缘卷起或向里翻折的