1.
A Method to Measure Vertical Axis Roll Angular Errors of Machine Tool Based on Laser Interferometer
基于激光干涉仪的垂直轴滚转角误差测量方法
2.
Secondly there is error between thethread roll angles of thread rolling die and drill rod.
滚丝轮螺纹和钻杆螺纹的螺旋角有误差。
3.
The Development of Dynamic Measuring Instrument for Checking Lead Errors of Ball Screws of Steering Mechanism
转向器滚珠丝杆导程误差动态检测仪的研究
4.
Research on Uncertainty of Rotating Angle Error of Servo Turntable
伺服转台回转角度误差的不确定度研究
5.
The error pickoff is an angle-to-voltage transducer.
误差检测器是把角度转换为电压的传感器。
6.
The adjustment of rotation angle error of power box twin export axles of twin screw extruder
双螺杆挤压机动力箱双输出轴转角误差调整
7.
Influence of Graduation Error of Dividing Disk on Error of Hob Chip Pocket Accumulated Pitch
滚刀开刃磨床分度盘误差对滚刀容屑槽周节累积误差的影响
8.
The Framework Desing of Measuring Head in Rolling-wheel Method and the Research of Error Correction Caused by Rolling-wheel Deformation;
滚轮测量头结构设计及滚轮变形误差修正研究
9.
Formation Error of Archimedes Gear Hob and Its Correction
阿基米德齿轮滚刀的造形误差及修正
10.
Vibration Analysis of the Ball Bearing Exciting By the Rolling Surface Errors
滚动表面误差激励的球轴承振动分析
11.
The spectrum analysis of the transmission error;
Y38A滚齿机传动误差的频谱分析
12.
Error Analysis and Calculate for Gear Hob's Indexing Transmission Chain
滚齿机分度传动链的误差分析与计算
13.
Detection Method of Hob Helix Error Curve Based on Excel
基于EXCEL的滚刀螺旋线误差检测方法
14.
The first boundary error has to be weighted by rotations and second by displacements.
第一个边界误差要用转角来加权，而第二个则用位移来加权。
15.
The Experimental Calibration of Angular Acceleration Parameters of Strapdown Gyroscope on Three-Axis Turntable
捷联陀螺角加速度误差系数在三轴转台上的实验标定
16.
Signal acquisition and non-linear error compensation technique of random rotating angle measurement by laser interference
激光干涉任意转角测量信号的获得及误差补偿技术
17.
Forecast Model and Error Analysis of the Line-of-Sight Angular Speed of Short Range Missiles
近程导弹瞄准线转动角速度预测模型及误差分析
18.
Influence of turntable angular position reference errors on laser SINS calibration
转台角位置基准误差对激光捷联惯导标定的影响分析