1.
On Optimizing Technology of Thin Wall Tubes and Tube-sheet Welding in Ti Trans-heat Equipment Manufacture
钛制换热器薄壁管与管板焊接优化工艺
2.
Optimization Study on Welding Sequence of the Hull Profile Butt Welding
船体型材对接焊的焊接顺序优化研究
3.
Parameters optimization of fillet weld sealing joint in high pressure hydrogenation heat exchange
加氢换热器角焊缝密封接头焊接工艺参数优化
4.
Prediction for welding deformation reducing by welding sequence optimization of upper plate
顶板焊接顺序优化减小焊接变形的预测
5.
Simulation and Optimization of Bi-Slotsteel Welding Beam with the Clapboard Based on Finite Element Analysis
基于有限元带隔板双槽钢焊接梁焊接仿真优化
6.
Cause of Welding Cracks for Ti Equipment and Its Process Optimization in Winter
冬季施焊钛设备焊接裂纹成因及其工艺优化
7.
Optimizing on Welding Parameters of TCS Ferritic Stainless Steel;
TCS铁素体不锈钢焊接工艺参数的优化
8.
Application of LINGO Optimization Software used in Welded Beam
LINGO优化软件在焊接条设计上的应用
9.
Optimization Study on Welding Sequence of Side Beam of Welded Frame in 200km/h High-speed Powered Car Train-set;
200km/h高速动车组焊接构架侧梁焊接顺序优化研究
10.
Preprocessing of Welding Fe Simulation and Its Application in Welding Sequence Optimization for Missile Oil Tanks;
导弹油箱焊接有限元前处理实现及焊接顺序优化
11.
Optimization of Technics Parameters of Welding Robot CO_2 Gas Protecting and Welding Based on the Neural Network;
基于神经网络的焊接机器人CO_2保护焊工艺参数优化
12.
Optimization of Virtual Regulating and Controlling on Welding Residual Stress of Turbine Runner;
水轮机转轮焊接残余应力调控措施的虚拟优化
13.
Optimization of 12Cr1MoV Steam Conduit Welding and Heat Treatment Procedure in Thermal Power Plant;
火力发电厂12Cr1MoV导汽管焊接及热处理工艺的优化
14.
Study on Optimization Methods of Computer-aided Welding Material Design;
计算机辅助焊接材料优化设计方法研究
15.
Analysis of Effect Factors and Parameter Optimization on Explosive Cladding Quality;
爆炸焊接质量的影响因素及参数优化分析
16.
Numerical Analysis and Optimization Research of Welding Volutes for Centrifugal Compressors;
离心压缩机焊接式蜗壳流动分析与优化研究
17.
CAE Analysis and Optimal Design of the Door Welding Assembly;
乘用车车门焊接总成的CAE分析与优化设计
18.
CAE Optimal Design of Casting Process of Steel Casting for Welded-structure Part
焊接结构用铸钢件的铸造工艺CAE优化设计