说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 铰接板梁桥
1.
Applied study on method of calculation of transverse load distribution for articulated slab girder bridges
铰接板梁桥荷载横向分布计算方法应用研究
2.
Study on Defction of Transverse Joints of Simply-Supported Hollow Slab Girder Bridges
空心板简支梁桥横向铰接缝病害分析
3.
Dynamic Assessment About Existing Simply-supported Hinge Joint Celluar Slab Bridges
既有简支铰接空心板梁桥结构状况动力评估
4.
Application of grillage method in analysis of simply-supported hinged joint celluar slab bridge testing and strengthening
梁格法在既有简支铰接空心板梁桥检测与维修加固计算分析中的应用
5.
On matrix analysis of articulated beam in Bridge Project and program calculation
桥梁工程铰接梁法的矩阵分析与程序计算
6.
Test on damage assessment of hinged concrete T-beam bridge system
混凝土铰接T梁桥结构体系损伤评价试验
7.
Research on Performance of Shear Connectors on the PC Box-girder Bridge with Corrugated Steel Webs
波形钢腹板PC箱梁桥剪力连接件研究
8.
Crossing Bridges: Wooden planks serve as bridges linking the buildings.
通过桥梁:木制的长板形成桥梁连接不同的建筑物。
9.
Stringer webs have cracked in suspension bridges at the stringer-floor bean connections.
在悬索桥的纵梁和横的连接处,纵梁的腹板上发生开裂。
10.
Analysis of pivot bolt breaking for water gate of Xinqiao ship lock
新桥船闸闸门支铰连接螺栓断裂分析
11.
The Stability Performance of RC. Curved Girder Bridge Supported by Single-Column;
独柱单点铰支承砼曲线梁桥的稳定性能研究
12.
Analysis of the Linked Fissure Destruct Reason of Road and Bridge and the Preventable Measure;
公路桥梁铰缝破坏原因浅析与预防措施
13.
Influence of Support Means of Hinge-Bearing for Container Crane's Boom on Lateral Vibration
岸桥前大梁铰支座支承对其横向振动的影响
14.
Cracks have been found in the flange and web splices at groove welds in at least four bridges.
至少在四座桥梁的翼缘板和腹板拼接坡口焊缝中发现了裂纹。
15.
In this paper, the construction method for the hinged steel bearings and hinged sliding plate bearings specially designed for the Bridge is presented.
介绍针对本桥专门设计的铰轴钢支座和铰轴滑板钢支座施工方法。
16.
ANALYSIS ON VEHICLE-BRIDGE COUPLING VIBRATION OF FRP DECK AND STEEL GIRDERS BRIDGE
FRP桥面板钢梁桥车桥耦合振动分析
17.
The Joint Strength of Low-floor Vehicles in Light Rail Transit
低地板轻轨车辆车体连接铰强度分析
18.
The ultimate load of plate girders was analyzed by spline finite strip and plastic hinge method.
用样条有限条塑性铰法分析了板梁的极限荷载。