1.
Stress Analysis of Composite Laminate Connected by Preloaded Bolt
复合材料层合板预紧螺栓连接应力分析
2.
Influence of Bolt Pretightening Force to GIS Shell Flange Intensity
螺栓预紧力对GIS壳体法兰强度的影响
3.
High-strength bolts were inserted into the holes and tightened to a high preload level.
把高强度螺栓插入孔洞，同时拧紧螺栓达到高的预加载水平。
4.
Analyze on bolt pre-tightening force control methods of Ba-Tong damper
八通缓冲器联接螺栓预紧力控制方法分析
5.
Two Ways of Calculating General Pulling Force of Tight Screw Bolt Linking with Beforehand Light Strength and Work Pulling Force;
受预紧力和工作拉力的紧螺栓联接的总拉力的两种计算方法
6.
Studies on the Ways of Calculating General Pulling Force of Tight Screw Bolt Lin king with Beforehand Light Strength and Work Pulling Force;
受预紧力和工作拉力的紧螺栓联接的总拉力计算方法研究
7.
tightening bolt
拉紧螺栓，(铁)风口拉杆
8.
Improper bolt tightening procedure.
螺栓拧紧程序错误。
9.
maneton clamp bolt
可拆卸曲柄颊夹紧螺栓
10.
square collar-head set-bolt
方头凸缘端紧定螺栓
11.
" Tolerances for fasteners--Bolts, screws and nuts"
GB/T3103.1-1982紧固件公差螺栓、螺钉和螺母
12.
Design Methods for Pre-tightening Forces and Permitted External Forces Acted on a Bolted Joint Based on 3D FEM Computation;
基于有限元计算的螺栓接头预紧力和允许外力设计方法
13.
a hand tool that is used to hold or twist a nut or bolt.
用来上紧或扭螺母或螺栓的手工具。
14.
Fasteners--Clearance holes for bolts and screws
GB/T5277-1985紧固件螺栓和螺钉通孔
15.
Hold puller screw and tighten puller nut until bushing is remove
握紧拉拔器螺栓，拧紧拉拔器螺母，直至拆下衬套。
16.
" Mechanical properties of fasteners--Bolts, screws and studs"
GB/T3098.1-1982紧固件机械性能螺栓、螺钉和螺柱
17.
hydraulicdevice for tightening tie-bolt
贯穿螺栓上紧用液压装置
18.
Lock rings at the end of shaft with bolt
GB/T892-1986螺栓紧固轴端挡圈