1.
Annealing hardening of nanocrystalline Ni-Fe alloy coatings synthesized by brush plating using soluble anode
可溶性阳极电刷镀纳米晶Ni-Fe合金镀层的退火再强化
2.
Effect of the Recrystal Texture During the Continuous Annealing Process by the Chemical Composition and the Temperature
化学成分及退火温度对连续退火再结晶织构的影响
3.
A Study on the Annealing Process and Mechanical Properties of Phase Transformation Hardened 980MPa Cold-rolled Steel Sheets
相变强化980MPa冷轧钢板的退火工艺和性能研究
4.
The reducing annealing furnace is adopted.
采用无氧化还原退火炉。
5.
The rate of reannealing is inversely proportion to sequence complexity.
再退火速度是和顺序复杂性成反比例。
6.
The Study for the Effect of Recrystallization Annealing on Structure and Texture of IF Steel;
再结晶退火对IF钢组织、织构影响的研究
7.
Research of Batch Annealing Process for Cold Rolled Adding P High Strength IF Steel Plate
加磷高强IF钢冷轧板罩式退火工艺研究
8.
Effect of Cold-rolled and Annealing Conditions on the Properties of High-strength IF Steel
冷轧和退火条件对高强IF钢性能的影响
9.
So, those not-so-strong imagines become dreams.
于是，不再强烈的臆想退为梦境。
10.
The procedures of heat treatment of steel include hardening,tempering,annealing and case hardening.
钢的热处理工序包括硬化、回火、退火和表面硬化。
11.
A satificatory effect is obtained by rime annealing.
采用再结晶退火工艺处理，可取得满意效果。
12.
Study on Recrystallization Behavior of Ferritic Rolled IF Steels;
铁素体区轧制IF钢退火过程再结晶规律的研究
13.
Study on Compression Deformation and Annealing Recryastallization of AZ31 Magnesium Alloy;
AZ31镁合金压缩变形及退火再结晶的研究
14.
Study on Evolution Law of Recrystallization Textures in Ti-IF Steel During Annealing
Ti-IF钢罩式退火过程中再结晶织构演变规律研究
15.
Mechanism on Annealing Recrystallization of Al-Zn-Mg-Cu-Sc Alloy
Al-Zn-Mg-Cu-Sc合金的退火再结晶机制研究
16.
Influence of recrystallization annealing on microstructure and texture of the RE aluminum foil
再结晶退火对稀土铝箔组织与织构的影响
17.
EBSD investigation of cold-rolled non-oriented silicon steel in recrystallization annealing process
冷轧无取向硅钢再结晶退火过程的EBSD分析
18.
Optimize the Parameters of Technics to Increase Quality of Products
优化退火炉工艺参数提高连退产品质量