1.
Research on pulsed MIG welding for heavy thickness aluminum components without preheating
大厚度铝构件无预热状态下的脉冲MIG焊
2.
Wire-DEM on the Heavy-Thickness and Thin -Wall Alumium Alloy Special Parts
铝合金大厚度薄壁异形件的线切割加工
3.
Calculation on effective section properties of aluminum alloy members based on effective thickness method
基于有效厚度法的铝合金构件有效截面特性计算
4.
Thickness Homogeneity Control Technology for Aluminum Alloy Conical Parts
铝合金锥形挤压件厚度均匀性控制技术
5.
Thick Plate Weld Technique in the Large-Scale Steel Framed of Plant Building
厂房大型钢结构厚板构件的焊接技术
6.
The results show that the casting density decreases with the thickness of coa-ting and polystyrene pattern increasing.
结果表明，涂层厚度与聚苯乙烯模样厚度增加，铸铝件密度下降、孔增加。
7.
Thickness effects on fatigue properties of cracked aluminum alloy plate single-side repaired with boron fiber/epoxy patches
铝合金板厚度对硼/环氧补片单面修复试件疲劳性能的影响
8.
maximum sawing or filling thickness of work
工件锯割或锉削最大厚度
9.
Study on Squeeze Processing of ZA Alloy Casting with High Ratio of Height to Thickness;
大高径（厚）比锌铝合金铸件挤压铸造工艺技术研究
10.
Numerical Approach to the Influence of the Protective Layer Thickness on the Mechanical Properties of the Reinforced Concrete Beam
保护层厚度对构件断裂影响的数值模拟研究
11.
Study on the High-speed Milling Process for the Weak Rigidity Workpieces of Anti-rust Aluminum Alloy
防锈铝合金弱刚度复杂构件高速铣削工艺研究
12.
Direct strength method for calculation of the bearing capacity of thin-wall aluminum alloy members under axial load
薄壁铝合金轴压构件承载力计算的直接强度法
13.
Experimental Study on High Speed Milling Low-rigidity Structure Part of Aluminium Alloy
铝质弱刚度结构件的高速铣削试验研究
14.
Fragmentation, Liu Yu-thick cut pieces of the system-Hill, excellent ornamental effect.
块度大，玉料厚实，琢制山子件，观赏效果佳。
15.
Measuring thickness of the aluminium foil--Weighing method
GB/T6608-1986铝箔厚度的测定称量法
16.
The aluminum sheets cannot be too much thicker than 0.04 inches.
铝板厚度不能超过0．04英寸。
17.
Study on MIG welding process of medium thickness 7A05 aluminum alloy
中厚度7A05铝合金MIG焊接工艺研究
18.
A corroded layer of thickness change.
砖间界面后形成了一厚度显微结构变化不大。