1.
Thin-Walled Steel I-Girders Subjected to Eccentric Patch Loading;
薄壁工字形钢梁在小片荷载偏心作用下的承载力
2.
Strength of Ⅰ-Girders with Delta Stiffeners Subjected to Eccentric Patch Loading
小片荷载偏心作用下具有三角加劲肋的Ⅰ型梁的强度分析
3.
The smallest load capable of maintaining the bar in a slightly bent form is called the critical or bucking load.
使杆保持稍微弯曲形状的最小载荷称为临界载荷或临界压曲载荷。
4.
location of gasket load reaction
垫片载荷作用位置处的直径
5.
Research on the Aerodynamic Load of Wind Turbine Blade Model
风力发电机组叶片模型气动载荷研究
6.
Study on Load of the Wind Turbine Blade Based on ANSYS
基于ANSYS风力机叶片的载荷研究
7.
Fragment distribution analysis of masonry wall under blast load
爆炸荷载作用下砌体墙碎片分布分析
8.
Analysis on the wind turbine's blade loads in 3D turbulence
风力机叶片在三维湍流下的载荷分析
9.
The forces affect the quality of the chip, cutting energy consumption, and load of the machine.
这些力的状况影响木片质量、削片能耗及削片机的载荷。
10.
Loading Conditions. The selection of loading conditions follows the determination of the type and magnitude of the loads that act on the structure.
荷载条件。确定了作用在结构上的荷载类型大小之后，接着要选择荷载条件。
11.
A Study of Computation Model with Load-structure Method for Unsymmetrically Loaded Closely-spaced Tunnel;
偏压小间距隧道的荷载结构特性研究
12.
Load Factor Analysis for Bird Impacting on Blades by Numerical Simulation Method
鸟撞击叶片时载荷因素的数值模拟分析
13.
Thermal Stress Analysis of Stacking Chip Scale Package under Power Load;
功率载荷下叠层芯片尺寸封装热应力分析
14.
Simulation and Experiment of Aerodynamic Load for Wind Turbine Blade Model
风力机叶片模型气动载荷的仿真与实验
15.
Experiment research on cracks propagation in a thin copper strip under cyclic tensile loadings
铜片在循环拉伸载荷下裂纹扩展的试验
16.
The maximum load , span of supports YueLong brand type cable tray must be less allowable load and span of supports .
“跃龙”品牌系列电缆桥架的最大载荷、支撑间距应小于允许载荷和支撑荷和支撑跨距。
17.
The maximum load on a bearing should always be smaller than the relief load in order to avoid scuffing.
为了避免划伤，轴承上的最大负荷应该总是小于其卸载负荷。
18.
The maximum load on a bearing should always be smaller than the relief load in order to avoid scuffing and brineling.
为了避免划伤和压坑，轴承上的最大负荷应该总是小于其卸载负荷。