1.
Microstructure and property analysis of 0Cr18Ni9Ti joints welded by ultra-sonic pulse tungsten-inert-gas welding technology
0Cr18Ni9Ti超音频脉冲TIG焊接头组织与性能
2.
Ultrasonic frequency pulse tungsten inert gas welding power source topology and welding applicability
超音频脉冲TIG焊电源拓扑及电弧焊适用性
3.
Dual DSP Parallel Processing Digital Control System for Ultra-audio Frequency Pulsed TIG Welding Power
超音频脉冲TIG焊电源的双DSP并行全数字控制系统
4.
INFLUENCES OF ULTRASONIC PULSE SQUARE-WAVE CURRENT PARAMETERS ON MICROSTRUCTURES AND MECHANICAL PROPERTIES OF 2219 ALUMINUM ALLOY WELD JOINTS
超音频脉冲方波电流参数对2219铝合金焊缝组织和力学性能的影响
5.
Tone or Pulse Dialing
设置音频或脉冲信号
6.
Generation of Broad Band Microwave Pulses by Ultrashort Optical Pulses
利用超短光脉冲产生宽频带微波脉冲
7.
Characteristics of pulse code modulation for voice-frequencies
GB/T7610-1987音频脉冲编码调制特性
8.
Make sure the Tone or Pulse setting is correct for your telephone system.
确保电话系统的音频或脉冲设置完全正确。
9.
An Embedded Speech and Audio Codec based on Factorial Pulse Coding
一种基于阶乘脉冲编码的嵌入式语音频编码器
10.
impulse bandwidth
脉冲(频)带宽(度)
11.
Recording of three dimensional spectrum of ultrasonicpulsed Doppler flow with micro-processor
用微机描记超声脉冲多普勒血流频谱三维图
12.
Pulse waveform design based on the combination of multiband APSWFs for UWB system
基于多频带APSWFs组合的超宽带脉冲波形设计
13.
Microbubble displacement under ultrasonic chirp excitation
调频超声脉冲驱动微气泡运动偏移的研究
14.
Frequency domain sampling and receiving method for ultla-wideband pulse signal
超宽带脉冲信号的一种频域采样和接收方法
15.
Ultrashort and medium frequency pulse electrotherapy treatment of infrapatellar fat pad injury
超短波并中频脉冲电疗治疗髌下脂肪垫损伤
16.
Special Group-Velocity Mode in Process of Third-Harmonic Generation of Ultrashort Pulses
超短脉冲三倍频中特殊群速度组合的分析
17.
Frequency sampling-based method to design UWB pulse shapes
基于频率采样的超宽带脉冲信号设计方法
18.
You measure frequency responses of loudspeakers crossovers, distortion of any audio equipment and impulse responses of loudspeaker systems.
可以测量扬声器的频率反应，任何音频设备的失真和脉冲。