1.
Stochastic Assessing Method of Voltage Sag Frequency Considering System Operating Modes and Time-Varying Fault Rate
考虑运行方式和时变故障率随机评估电压凹陷频次
2.
Transformer Fault Diagnosis Based on Probabilistic Neural Networks;
基于概率神经网络的变压器故障诊断
3.
The model of the failure probability distribution was obtained by applying total failure time method for the numerical control punch.
运用故障总时间法初步确定数控冲床的故障概率模型。
4.
For the jumping faults of sensors, substituting control is used during jumping.
对于传感器出现的跳变故障，则在跳变故障的时间内采用取代控制。
5.
Fault Diagnosis of a Kind of Linear Parameter Varying Time-delay Systems
一类线性变参数时滞系统的故障诊断
6.
part failure rate
零部件故障率零件故障率
7.
Failure Detection for Cast Steel Pedestal Based on Frequency
一种基于频率变化的铸钢支座故障识别方法
8.
Research on the Faults Characteristics and the Fault Diagnosis Methods of Three-level High-power Inverter
三电平大功率变频器故障特征及诊断方法研究
9.
Mutation Failure Analysis for PDM Pulse Frequency Compensation of DF100A Shortwave Transmitter
DF100A短波发射机PDM补偿脉冲频率突变故障分析
10.
Test and Fault Analysis for High Power High Frequency High Voltage Transformer
大功率高频高压变压器的试验及故障分析
11.
observed mean failure rate
平均故障率的观察值
12.
Study on Transformer Fault Real-time Digital Simulation and Closed-loop Test
变压器故障实时数字仿真及闭环测试的研究
13.
Fault accommodation for a class of linear time-varying systems with parametric uncertainties
一类参数不确定的线性时变系统的故障调节
14.
Transfer of Fault Through Transformer in Single-phase Short Circuit Protection
单相接地短路时故障量经变压器的传递
15.
Analysis of Relay Protection Responding to a Transformer Fault
一起变压器故障时继电保护动作行为的分析
16.
Design of H_∞ fault detection filter for linear continuous time-varying systems
线性连续时变系统H_∞故障检测滤波器设计
17.
Given the failure rates for given subsystems, the Six Sigma Black Belt will be able to use reliability apportionment to set mtbf goals.
给出给定子系统的故障率，6西格玛黑带应能利用可靠性分配原则设定平均无故障时间目标。
18.
In the event of a fault, the computer can calculate the fault's current values and characteristics, and settings can be changed merely by reprogramming.
在系统出现故障时,计算机可计算出故障电流牟值和特性,整定值的改变仅改变编程就可以了。