1.
high pressure nozzle spray drier
高压喷嘴式喷雾干燥机
2.
Prior to entering the nozzle, the steam is at high pressure.
在进入喷嘴之前，蒸汽处于高压状态。
3.
CFD Simulation of High-Pressure Water Descaling Nozzle Jet Characteristic;
高压水除鳞喷嘴射流特性的CFD仿真
4.
Research on High-pressure Water Mist Nozzle and Its Characteristics of Fire Suppression;
高压细水雾喷嘴及其灭火性能的研究
5.
Effect of High-pressure Ammonium Carbamate Injector Nozzle Cracking on System
高压甲铵喷射器喷嘴呲裂对系统的影响分析
6.
A high-velocity fluid stream forced under pressure out of a small-diameter opening or nozzle.
喷射流体在压力迫使下从小喷嘴或小孔中喷出的高速流体
7.
Numerical and Simulation Research on the High Pressure Water Jet Nozzle in Inside and Outside Efflux Flow Field;
高压水射流喷嘴内外部流场的数值模拟研究
8.
The 3D Numerical Simulation of the Flow Field and Experiment Study on High-pressure Water Descaling Nozzle;
高压除鳞喷嘴流场三维数值模拟与试验研究
9.
Experimental Research on Parameters of Nozzle Slotted in Non-submerged High Pressure Swirling Jet
非淹没高压旋转水射流喷嘴割缝参数试验研究
10.
Reduce pressure. Use a larger nozzle. Hold spray gun closer to the surface. Spray at right angles to the surface.
改变压力。使用大一点的喷嘴。加近喷枪与底材的距离。调整高度。
11.
Test results show that the corona's onset and breakdown voltage both rise with increasing OD of the nozzle.
结果表明:喷嘴外径增大,起晕电压和击穿电压升高。
12.
Analysis of High Pressure Assisted Gas Flow in Laser Cutting and Improvement of Nozzle Structure;
激光切割中高压辅助气体流场分析与喷嘴结构改进
13.
Flow Field Analysis on High Pressure Abrasive Water Jet Cutting Nozzle and Optimization on Parameters of Nozzle;
高压磨料水射流切割喷嘴流场分析及结构参数优化研究
14.
Study on the Atomizing and Humidifying Character of the Centrifugal Nozzle with Firing Pin Type, High Pressure and Little Aperture;
撞针型高压小孔径离心式喷嘴雾化加湿性能的研究
15.
The Jet Characteristics Theory Analysis and Numerical Simulation of Oil Well High Pressure Water Rock Breaking Nozzles
油井高压水破岩喷嘴射流特性的理论分析与数值模拟
16.
Numerical Simulation Study on Structure Design and Parameters Optimization of High Pressure Water Jet Cutting Nozzle
高压水射流切割喷嘴的结构设计和参数优化数值模拟研究
17.
Multidisciplinary Design Optimization for Fuel Nozzle of High Pressure Common-Rail Injection System Based on Self-Adaptive Particle Swarm Optimization Algorithm
自适应粒子群优化的高压共轨燃油喷嘴多学科优化设计
18.
Numerical simulation for the influence of structure parameters of ultra-high pressure taper nozzle on the micro-fluidization
超高压锥形喷嘴结构参数对微射流影响的数值模拟