1.
A Control Method for BLDCM Used in Robotic Tool for Disassembling Screw Nuts
自动拆卸螺母工作头的电机控制研究
2.
Design of a Robotic Tool to Disassemble Screw Nuts
自动拆卸螺母机器人工具的机械设计与研究
3.
Remove the engine cylinder head bolts.
拆卸引擎汽缸头螺栓。
4.
Slide the headlamp bucket downward to disengage it from the headlamp adjusting screws.
向下滑动头灯槽以将其由头灯调整螺丝拆卸。
5.
Remove the Model 7 from the line (union nut and adapter remain in the line).
从管道上拆卸型号7（接头螺母和适配器留在管道上）。
6.
The body halves are then separated by removing cap screws and hex nuts.
拆卸了盖螺丝和六角螺母后，阀体就分为两半。
7.
multi-station automatic nut cold header
多工位螺母自动冷镦机
8.
To examine diaphragm, disassemble coupling nut (6) and lift off pressure plate (7).
检查隔膜，拆卸连接螺母(6)并提升压力板(7)。
9.
Remove the nut and bolt attaching the track bar to the track bar mount on the body of the vehiclRemove the track bar from the track bar mount.
拆卸接合横拉杆与位于车身之横拉杆固定座的螺帽与螺栓。将横拉杆自横拉杆固定座拆卸下来。
10.
Remove the flywheel or converter drive platDiscard the old bolts.
拆卸飞轮和转换器驱动圆盘。扔掉旧的螺栓。
11.
maneton clamp bolt
可拆卸曲柄颊夹紧螺栓
12.
Remove screws at wheel opening.
拆卸车轮孔处的螺丝。
13.
Remove rear lower suspension arm bolts.
拆卸后下端悬吊臂螺栓。
14.
Seat Cushion Cover Retaining Clip Removal
座椅垫盖固定螺钉拆卸
15.
Lower Ball Stud Remove/Install
上圆顶螺栓拆卸/安装
16.
Remove the upper and lower ball stud nuts.
拆卸上、下圆顶螺栓。
17.
Remove caliper mounting bolts .
拆卸夹制器固定螺栓。
18.
The stevedores'work is to load and unload ships.
(码头)装卸工人的工作是装卸船只。