1.
Experiment on tensile and shear strength of front fillet welded joint post-high-temperatures
高温后正面角焊缝抗拉剪切强度的试验
2.
Study of Length Calculation of Three Side Welded Lap;
三面围焊搭接角焊缝长度计算的探讨
3.
And the weld width decrease with welding speed being increased.
而焊接速度的增大,焊缝正面和背面的熔宽明显减小。
4.
The box corner welds were made with E70 electrodes.
箱型梁内角部焊缝所用的电焊条为E70。
5.
Quality Control of the Fillet Weld in the Tube and Tube Sheet of Heat Exchanger
换热器管-管板角焊缝焊接质量的控制
6.
Both single and double fillet welds shall be as follows unless otherwise shown on the drawing.
除非图上另外标明，所有单、双面贴角焊缝高度如下。
7.
Amendment to the Weld Reinforcement Measurement of SAW Pipe with General Welding Measurement Ruler
通用焊接检验尺测量埋弧焊管焊缝余高的修正
8.
Process model of arc corrugation on friction-stir weld
搅拌摩擦焊焊缝表面弧形纹形成模型
9.
Automatical EB Welding of Curved Weldment
工件平面曲线焊缝的电子束自动焊接
10.
Parameters optimization of fillet weld sealing joint in high pressure hydrogenation heat exchange
加氢换热器角焊缝密封接头焊接工艺参数优化
11.
Application of ultrasonic sensor in automatical welding of right-angle welding seam
超声波传感器在直角焊缝自动焊接中的应用
12.
Analysis on welder's operating methods influencing quality of fillet weld of stainless sheet plate
焊工操作手法对不锈钢薄板角焊缝质量的影响
13.
All corners are carefully intersected so that a cross is visible on the right side of the fabric.
所有的拐角都要仔细地交叉缝,所以十字记号在面料的正面可见。
14.
Effect of Outside Welding Groove Angle on Weld Quality of X80 Grade SSAW Pipe
外焊坡口角度对X80级螺旋埋弧焊管焊缝质量的影响
15.
Analysis of Bubbling on the Surface of FSW Welding Seam
2A14铝合金搅拌摩擦焊焊缝表面鼓包原因分析
16.
According to the theory of bearing forces and deformations, this paper gives distribution laws of the shearing stresses in the side fille welds of overlap connection with comparative accuracy.
依据受力与变形理论,较为精确地给出了搭接接头侧面角焊缝中的剪应力分布规律。
17.
"Providing good maintenance practices and correct weld parameter setting are done, no weld breaks are expected and no rewelds are necessary. "
只要维修良好,焊接工艺参数设定正确,不会出现焊缝断裂,不必重焊。
18.
A Research into the Basic Formulation of the Calculation of the Welded Seam Strength of Right-Angle Welded Seam;
关于直角角焊缝强度计算基本公式的探讨