1.
Research on a Newly Combinational Tri-turned Crankshaft for Diaphragm Pump
新型组合式隔膜泵用三拐曲轴的研究
2.
triple-barrel pump
三联式筒泵(三个泵筒与一个吸液管相连，由三拐曲轴驱动三个活塞产生均匀液流)
3.
Analysis of Inspection and Measuring Method for 120° Distributing Angle Errors of Crankshaft Crankpins
曲轴曲拐120°角度误差检测方法分析
4.
Research on the Upset Forging Technology of Marine Crank of 305 Crankshaft
船用305曲轴曲拐镦锻成形工艺研究
5.
Analysis on Measuring Accuracy in Inspecting Crank Angles for Six-cylinder Crankshafts
六缸发动机曲轴曲拐夹角检测方法的精度分析
6.
Study on Making Process and Mould Structure of None-phase Angle Crankshaft with Four Cylinder Sleeve
无相位角四拐曲轴的制坯工艺及模具结构优化
7.
Thus a normal loom has two shafts. The main shaft(crankshaft or top shaft) drives the lay mechanism and is geared to another shaft which operates at half of the speed of the crankshaft.
这样,普通织机应具备两根轴,主轴(曲拐轴或位于上部的轴)驱动筘座并通过齿轮驱动另一根轴。
8.
Research on Planar Cubic PH Spline and the Inflection Points and Singularities on F-curve
三次插值PH样条与F-曲线拐点和奇点的研究
9.
and take the third turning on the left.
在第三个拐弯处向左拐，
10.
Three Dimensional Entity Modeling and Modal Analysis of Crankshaft on APDL
曲轴APDL三维实体建模与模态分析
11.
crankshaft (main journal turning lathe)
曲轴（主轴颈）车床
12.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
13.
Inflection Point
拐点，弯曲点，转折点
14.
APPLICATION OF 3D BOUNDARY ELEMENT METHOD IN SHAPE-STRUCTURAL OPTIMIZATION OF CRANKSHAFTS
三维边界元法在曲轴结构形状优化中的应用
15.
The Crank Balance and Vibration Measurement on a Three-Cylinder Car Engine
三缸汽车发动机的曲轴平衡与振动测试
16.
Refined Method of Modeling ICE Crankshaft-Flywheel for 3-D Vibration Analysis
内燃机曲轴的三维振动特性模拟——飞轮细分
17.
Recovering the Geometry of Single Axis Motions by Conic Fitting;
基于二次曲线的单轴旋转运动分析和三维重建
18.
Research on the Boundary Conditions of the Whole Crankshaft s Three-dimensional Analysis;
曲轴整体三维分析边界条件模拟的研究