1.
Discussion on Proficiency Testing Process of Copper Winding Temperature-Rising Test
铜质绕组温升试验能力验证过程讨论
2.
CaIcuIation and Analysjs of Short Circuit Strength,Temperature RiSe and EIectric FieId in Windings of Power TranSformer
电力变压器绕组短路强度、温升、电场计算与分析
3.
Calculation and Design of Temperature Rise of Upper End Line Section in Large Transformer Winding
大型变压器绕组上端部线段的温升计算与设计
4.
"Should the motor winding temperature rise excessively, the thermostats will open before the temperature can reach a level that can cause damage to the motor."
一旦电机绕组温度升得过高,并可能达到会对电机产生损坏之前,温控器将自动开启。
5.
EXPERIMENTAL AND SIMULATION STUDY ON BONFIRE TEST OF HIGH-PRESSURE HYDROGEN STORAGE VESSELS
纤维缠绕高压氢气瓶火烧温升试验及数值研究
6.
Modeling and Application of Internal Nonsteady-state Temperature on the Coil Winding
绕组内部非稳态温度场建模及其应用
7.
Improved Method for Calculation of Hot-spot Temperature in Power Transformer
改进的变压器绕组热点温度估算方法
8.
Research of the Oil-Immersed Transformer Windings Temperature Measurement on Line;
油浸式变压器绕组温度在线测量的研究
9.
The Study of the Eddy Losses and Temperature Field of Winding in Power Transformer;
电力变压器绕组中的涡流损耗及其温度场研究
10.
The Study of Temperature Field of No-Encapsulated-Winding Dry-Type Power Transformer and Its Structural Optimization;
非包封干式变压器绕组温度场研究及结构优化
11.
Two Dimensional Simulation Analysis of Winding Temperature Field of Oil-Immersed Power Transformer
油浸式电力变压器绕组温度场的二维仿真分析
12.
Thermal Model for Hot Spot Temperature Calculation in Oil-immersed Transformers
油浸式变压器绕组热点温度计算的热路模型
13.
Application of All-Fiber Technology about Temperature Measurement on Transformer Winding
全光纤技术在变压器绕组在线测温中的应用
14.
The FBG Monitoring Principle of Transformer Internal Temperature and the Improved Method for Calculation of the Hot-Spot Temperature
变压器内部温度光纤传感监测及绕组热点温度计算改进方法
15.
top of slot belt
上层绕组区 -双层绕组的
16.
Heating of Isolated Tissues by Self-Regulating Thermoseeds
热籽磁感应加温在离体组织中的升温情况
17.
Microstructure Transformation during Ramp-up of Weld in Brazing Copper with Cu-P Amorphous Fillers
非晶铜磷钎料升温过程中的组织演变
18.
During and after each test, the temperature of the windings shall not exceed the values specified in table8.
在每一次试验期间和之后,绕组温度不应超过表8中的规定值。