1.
Wall form installation please see attached sketch No.-4. Expended cement mortar shall be used for sealing after form dismantled and pull bolts removed.
墙板模板安装见附图4。在模板拆除对拉螺栓拿出后，采用微膨胀水泥砂浆封堵。
2.
Reserch on Printed Circuit Board Electronic Components Dismantling Model and Experiments
电路板电子元件拆除模型与实验研究
3.
Heat/Defrost Panel/Defrost Door Motor Remove/Install
加热/除霜 薄板/除霜门马达拆卸/安装
4.
Remove the door module from the trim panel.
从饰板上拆卸车门模组。
5.
Remove the defroster duct from the instrument panel.
从仪表板上拆下除霜器导管。
6.
Remove the panel/demist door vacuum actuator from the vehicle.
从车辆拆卸仪表板/除霜门真空引动器。
7.
So, the existed high-piled slab &beam wharf shall he demolished.
为此，需将旧的高桩梁板码头拆除。
8.
Blasting Demolition of Flood Damaged Reinforced Concrete Floor of Spillway
溢洪道水毁钢筋混凝土底板爆破拆除
9.
The Study of Early-dismantling Template System and Dismantling Template Time of Concrete Structure;
混凝土结构早拆模板体系与拆模时间的研究
10.
Remove the door trim panel as described in Door Module (front door) or Power Window Switch (rear door) in this group.
按本单元的“车门模组”（前车门）或“电动窗开关”（后车门）中所描述的方法拆除车门饰板。
11.
if they refuse to do so, they shall be ordered to pull them down.
拒不拆除的，责令拆除。
12.
DISCONNECT & REMOVE THE BODY CONTROL MODULE FROM THE JUNCTION BLOCK.
从集成板上拆下并移走主体控制模组。＊
13.
THE TECHNOLOGY OF ASSEMBLED FIELD-CAST CONCRETE WALL WITHOUT DEMOULDING
拼装式现浇混凝土墙体免拆模板技术
14.
The Application and Development of Earlier Disassembly System of Formworks in Construction;
模板早拆体系在施工中的应用和发展
15.
Experimental Study on Non-Dismantling Template of the Concrete Contains Glass Fiber
玻璃纤维混凝土免拆模板的实验研究
16.
An Analysis of the Causes of Titanium Plates Removal After Rigid Internal Fixation for J aw Fractures
颌骨骨折内固定术后钛板拆除的原因分析
17.
Research on the Dismantling Technology and Equipment for Electronic Components on Discarded PCBs;
废弃电路板电子元件拆除技术研究及设备研制
18.
Airbag Control Module Connector Removal
安全气囊控制模组接头拆除