1.
Study on effect of organic silicon resin on capability of epoxy resin cast
有机硅树脂对环氧树脂浇注体性能的影响
2.
Technical specification for integralpouring antistatic terrazzo floor
整体浇注防静电水磨石地坪技术规程
3.
Freeze Casting of Reaction Bonded Silicon Carbide;
反应烧结碳化硅坯体的冷凝浇注成型
4.
Discussion of Plan for Massive Concrete Placing of Pump Gate Floor
泵闸底板大体积混凝土浇注方案讨论
5.
Study Properties of Cast Polyurethane Elastomers Based IPDI
IPDI基浇注型聚氨酯弹性体性能的研究
6.
Difference between castable amount per unit volume and bulk density
耐火浇注料单位体积用量与体积密度的差异
7.
The flow rate, beams result shows the amount and rate of polymer that is delivered through runners into the mold cavity, allowing you to optimize the runner system design.
柱体元素流动率?示柱体元素内塑料的流动率，主要是浇注系统，为优化浇注系统提供依据。
8.
Study of Calcining Entire?Cast Furnace Lid Made with Mullite?Fly Ash
莫来石—粉煤灰整体浇注焙烧炉盖的研究应用
9.
Using protection cast process in the whole course to debase the content of gas and inclusion.
采用全程保护浇注工艺降低气体和夹杂物含量 ;
10.
Study on Dynamic Performance of Cast Polyurethane Elastomers with High Property
高性能浇注型聚氨酯弹性体的动态性能研究
11.
Study on the Techniques of Gas Protected Melting, Pouring and Safety of Magnesium Alloys;
镁合金气体保护熔化浇注及安全技术研究
12.
Study on Large Volume Poured Cement Based Low and Intermediate Level Radioactive Waste and Mechanism of Cs Solidified;
中低放废液大体积浇注水泥固化及铯固化机理
13.
Design and Optimize the Running System of Cylinder Block and Numerical Simulation
发动机缸体浇注系统的优化设计与数值模拟
14.
Fabrication of Porous SiC Ceramics by Precursor Polymer-contained Slurry Slip Casting Method
含先驱体聚合物浆料浇注成型制备SiC多孔陶瓷
15.
Development of MDI Based Castable Urethane Elastomer Material
基于MDI浇注型聚氨酯弹性体密封材料的研制
16.
Design and Optimization of Gating System for Cylinder Block Based on Numerical Simulation
基于数值模拟的汽缸体浇注系统的设计与优化
17.
Design of Running System of Cylinder Block and Simulation of the Forming Process
气缸体浇注系统的设计与成形过程的模拟
18.
The Study of Flow Behavior of Plastic Melt in the Gating System of Injection Mold
塑料熔体在注射模具浇注系统中的流动行为研究