1.
Structural Modal Analysis for the Crankshaft/flywheel component of a 4-cylinder IC Engine
四缸内燃机曲轴-飞轮组结构模态分析
2.
Position flywheel and O-ring on crankshaft and align bolt holes.
安装飞轮和O形环在曲轴上并对齐螺栓孔。
3.
Refined Method of Modeling ICE Crankshaft-Flywheel for 3-D Vibration Analysis
内燃机曲轴的三维振动特性模拟——飞轮细分
4.
crankcase cam gear bushing
曲轴箱凸轮传动轴衬套
5.
Inspect crankshaft, flexplate/flywheel and bolts for damagTighten to correct torque
检查曲轴、活动板/飞轮和螺栓是否松动。拧紧螺栓以校正扭力。
6.
At the rear end of the crankshaft is attached the flywheel, and at the front end are the driving wheels for the timing gears, fan, cooling water and alternator.
曲轴的后端连接着飞轮，前端是连接着定时齿轮，风扇，冷却水和交流发电机的驱动轮。
7.
aircraft gas turbine bearing lubrication
飞机燃气涡轮轴承润滑
8.
crankshaft fan pulley
曲轴上的风扇皮带轮
9.
The camshaft rotates in phase with the crankshaft, but at half its speed.
凸轮轴和曲轴协调旋转, 但速度仅是曲轴的一半。
10.
Cause Analysis and Prevention of Main Shaft Bending of Bleeding Back-pressure Steam Turbine-Generator Unit
抽汽背压式汽轮发电机组大轴弯曲原因分析及预防
11.
Verify Crankshaft—Camshaft Installation—Typical
验证曲轴—凸轮轴安装—典型的
12.
High Speed Grinding with CBN Grit Wheel for Camshaft Manufacturing of Engine
发动机曲轴凸轮轴CBN高速磨削加工
13.
There is only one working stroke in four so a flywheel is needed to drive the crankshaft during the time that the engine is performing the non-power strokes.
因为4个工作冲程中只有一个冲程作功，所以发动机处于非作功冲程时，飞轮带动曲轴旋转。
14.
Group of Rapporteurs on Brakes and Running Gear
刹车和轮轴报告员小组
15.
Hub And Bearing Assembly Mounting Surfaces
轮毂轴承组件固定面
16.
Install the timing chain, crankshaft sprocket and camshaft sprocket with the timing marks aligne
安装正时链、曲轴链轮和凸轮轴链轮，使正时标记对齐。
17.
A Research on the Processing Technique of 300M Aircraft Landing Gear Steel Axle
飞机起落架300M钢轮轴加工工艺研究
18.
The ratio of the crankshaft to the revolutions of the camshaft is 2∶1.
曲轴的转速与凸轮轴的转速之比是2∶1。