1.
EX(d).ARMORED-CABLE PACKING GLAND
防爆铠装电缆密封接头
2.
WATER-PROOF ARMORED-CABLE PACKING GLAND
防水铠装电缆密封接头
3.
The Application of Rigid Polyurethane Cable Foam in Ship Cable Sealing
硬质聚氨酯泡沫塑料在船舶电缆密封上的应用
4.
Approach on Explosion Protected Cable Sealing Joint for Flameproof Motor
隔爆型电动机接线盒防爆电缆密封接头引入装置问题探讨
5.
pressurizing window
密封封口(电缆), 气密口
6.
sealing compound
电缆膏； 封口膏， 密封剂， 油灰， 腻子； 电瓶封口填料； 密封接合物
7.
Analysis and Improved Design of the Cable Entry Sealed Equipment of Submersible Pump
潜水电泵电缆引入密封装置的分析与改进设计
8.
wireline packer setting
电缆操作封隔器坐封
9.
Neoprene grommet and complete epoxy encapsulation provide for a true non-wicking cable entry. An isolating cable chamber is not needed.
氯丁橡胶绝缘垫圈和全部环氧树脂密封，提供真正的无芯电缆连接。不需要另外配置绝缘电缆盒。
10.
wireline pressure setting assembly
电缆工具压力坐封装置
11.
One end of the cable is permanently connected to the enclosed mercury switch and the entire assembly is encapsulated to form a completely watertight and impact resistant unit.
电缆的一端永久性连接在封闭的水银开关内,这个完整的密封总装形成完全不透水、抗撞击装置。
12.
"The power and control cable entry system shall be designed to provide a positive, leak-free seal to prevent liquid from entering the air filled motor housing."
电源和控制电缆的进入系统应该配置绝对的、无泄漏密封,防止液体进入风冷电机箱体。
13.
"Incorporates the same "construction features"as the Series 9100 for bearing design, shaft strength, mechanical seal system and cap/cable system"
轴承设计,轴长,机械密封系统和外罩／电缆系统等部件于9100系列泵完全相同。
14.
a Buna-N cable grommet or a strain relief fitting shall be provided in addition to the epoxy sealed leads.
除此之外,还应该配置丁纳橡胶-N电缆索环或应变消除接头,进一步强化环氧树脂密封接头。
15.
all conductor leads shall terminate at a terminal board that is permanently cast into the epoxy-sealed cable entry area.
所有导体接头都应该连接在接线端子板上,并采用环氧树脂永久密封在电缆进入区。
16.
hermetically-sealed superminiature electromagnetic relay
超小型密封电磁继电器
17.
Phenomenon of Corroded Sealant for Optical Cable Joint-case by Ants and Protection Method
蚂蚁蛀蚀光缆接续盒密封胶的现象及防护
18.
non-enveloped thermistor
非密封型热敏电阻器