1.
Cause of Excessive Temperature of Cover Bolt of Russia-made TBB-500-2EY3 Generator
俄制TBB-500-2EY3型发电机端盖螺栓温度高原因分析
2.
Install the bolts attaching the end cap to the front fender.
安装连接末端端盖到前挡泥板的螺栓。
3.
Optimal Design of the Main Bolt of Top Cover of the Ammonia Converter Based on ANSYS
基于ANSYS对氨合成塔端盖主螺栓的优化设计
4.
Breaking Reason and Solution of the Connecting Bolts Used in the Ball Mill End Cover
球磨机端盖法兰连接螺栓的断裂原因及其解决
5.
Pull back the wheelhouse liner and remove the bolts attaching the end cap to the front fender.
拉下舵手室外套，拆去连接末端端盖到前挡泥板的螺栓。
6.
Turn the hollow bolt so that it is fixed on the bake cover or the flange plate.
安装后必须旋出空心螺栓锁紧在电机后端盖或法兰盘上。
7.
cap-and-pin type insulator
帽盖穿心螺栓式绝缘子
8.
Remove rear lower suspension arm bolts.
拆卸后下端悬吊臂螺栓。
9.
square collar-head set-bolt
方头凸缘端紧定螺栓
10.
Remove the relief valve cover bolts while holding the cover down.
边压住阀盖，边拆卸安全阀阀盖螺栓。
11.
spring eye bolt
(弹簧的)环端螺栓，弹簧眼螺丝
12.
Stainless steel stuffing box hardware is standard (ie. bolts, gland studs, nuts, washers).
标准的金属密封不锈钢填料箱（如螺栓、填料压盖螺栓、螺母、垫圈）。
13.
Analysis on Fatigue Cracking of Cylinder Cap Bolt
缸盖螺栓接触损伤引发疲劳开裂分析
14.
Remove upper generator mounting bolt.
拆下上端发电机安置螺栓。
15.
Lock rings at the end of shaft with bolt
GB/T892-1986螺栓紧固轴端挡圈
16.
Tie Rod End To Steering Knuckle Nut
转向拉杆端与转向关节螺栓
17.
Remove vibration damper bolt and washer from end of crankshaft.
从曲轴端拆下减震器螺栓和垫圈。
18.
Tie Rod End Adjusting Sleeve Nut
转向拉杆端调整轴筒螺栓