1.
Two Simplified Finite Element Models for Contact Analysis of Ultrasonic Motor
超声电机接触界面的两种简化有限元模型
2.
Simplified two-dimension finite element model was established for the hollow rubber seal of hood-type annealing furnace.
建立了罩式退火炉空心橡胶密封圈的二维简化有限元模型;
3.
STRESS AND STIFFNESS ANALYSIS OF A SIMPLIFIED ADHESIVE BONDED FINITE ELEMENT MODEL CONSIDERING SPEW-FILLETS
一种考虑胶瘤的胶接简化有限元模型:应力与刚度分析
4.
Simplified Finite Element Model for Ultra High Voltage Composite Insulator
特高压复合绝缘子有限元模型的简化
5.
Preliminary Discussion of Dynamic Finite Element Simplified Model on Large Scale Vibrating Screen
大型振动筛动力学有限元简化模型初探
6.
Stability Analysis of Crawler Crane Boom System Based on Simple Finite Element Model;
履带起重机臂架有限元简化模型稳定性分析
7.
Research on Model Simplification and Geometry Clean in Finite Element Modeling for Bus Body
车身有限元简化建模与几何清理研究
8.
Calculation and FEM Analysis of Simplified Beam Model Based on Derivation of Rigidity Matrix;
基于刚度矩阵推导的车身梁简化模型的计算与有限元分析
9.
Method of Simplifying FEM Model of Underwater Cylinder in the Shock Response Analysis
水下圆柱壳冲击响应分析的有限元模型简化方法
10.
FEM Simulation and Simplified Calculation of the Settlement of the Raft Foundation;
筏板基础沉降的有限元模拟及简化计算
11.
Finite element analysis on modal frequency change regulations of the damage simple-supported beams
损伤简支梁模态频率变化规律有限元分析
12.
Simplified Analysis of the Stressed Skin Diaphragm of the Profiled Sheet on FEM;
压型钢板受力蒙皮作用的有限元简化分析
13.
Optimized Pass Design System of Angle Steel and Finite Element Simulation;
角钢孔型优化设计系统及有限元模拟
14.
Finite Element Simulation of Strain Localization Based on Cosserat Continuum Model;
基于Cosserat连续体模型的应变局部化有限元模拟
15.
Numerical simulation show that the results by CFM agree with those by FEM, and are much more accurate than those by PPM.
仿真结果表明 ,悬臂梁模型与有限元模型具有较高的一致性 ,它比简支梁模型更准确
16.
Analysis of clip-model of frictional welding with 3D finite elements
径向摩擦焊夹持模型优化设计三维有限元分析
17.
FEM Correction for the Guyed Mast Structure Based on Optimization;
基于优化原理的桅杆结构有限元模型修正
18.
FE Model Updating and Optimization Analysis on Body-in-white;
轿车白车身有限元模型修正与优化设计