1.
Structural Finite Element Analysis of Spindle Ram for Large-Scale Milling Planer
大型龙门铣床主轴滑枕结构有限元分析
2.
Design of the Balance Compensation Control System of Chief Axis Ram for the Floor-type Boring and Milling Machine MCMG 180 LG
MCMG 180 LG落地铣镗床主轴滑枕平衡补偿控制系统的设计
3.
temperature controlled spindle lubricating unit
温控式主轴润滑装置
4.
Analytical Investigation on Strength and Main Bearing Lubrication of CA4D32 Diesel Engine Crankshaft System Based on a Simulation Technique;
柴油机曲轴轴系强度和主轴承润滑仿真研究
5.
side bearing arch
中摇枕(三轴转向架)
6.
center bearing anchor bar
中摇枕拱板(三轴转向架)
7.
Experimental Research on Oil-Air Two Phase Lubrication of High Speed Motorized Spindle Rolling Bearing;
高速电主轴滚动轴承油气两相流润滑试验研究
8.
Main Bearing Lubrication Analysis Considering Crankshaft Elastic Deformation and Asperity Contact
考虑曲轴倾斜和摩擦接触的主轴承润滑分析
9.
Study on Lubricating Characteristics of Crankshaft Main Bearing for High-duty Diesel
高强化柴油机曲轴主轴承润滑特性研究
10.
Influence of oil temperature on lubricating performance for main bearing
机油温度对主轴颈轴承润滑性能的影响
11.
Application of Oil Gas Lubrication Technique to Bearing of High-Speed Motorized Spindle
油气润滑技术在高速电主轴轴承上的应用
12.
horizontal ram knee type milling machine
卧式滑枕升降台铣床
13.
mainshaft low and reverse sliding gear
主轴低速及倒车滑动齿轮
14.
Analysis of Lublication and Failure for Thrust Bearing in Cold Mill Main Motor
冷轧主电机止推轴承润滑与故障分析
15.
Experimental Research on Tribological Properties of Jewel Bearing and Oil-Air Lubrication of High Speed Motorized Spindle;
宝石轴承摩擦磨损及高速电主轴油气润滑的试验研究
16.
Research on the Load Capability of the Motored Spindle of Oil-air Lubricated Dynamic-static Slide Bearing;
油气二相流动静压滑动轴承电主轴承载性能研究
17.
Stability of Small-Sized Grooved Bearings-Spindle System in High-Speed Hard Disk Drive Considering Thermal Effect
高速硬盘微小型滑动轴承—主轴系统变温条件下的稳定性研究
18.
The Structure of New Journal Hybrid Bearing for High-speed Machine Spindle and Its Performance
新型高速铣床主轴水润滑动静压轴承结构及性能研究