1.
Double Layer Casting Process for M224 Type Internal Grinder Bed
M224内圆磨床床身铸件的双层浇注
2.
after a certain proportion of the concrete has been poured. The top level must be poured within twenty minutes of the pouring of the bottom level to assure proper bonding.
在浇注底层混凝土后20分钟以内须浇注面层混凝土以保证粘接牢固。
3.
Used as linings, bottoms in electrolytic cells, smelting furnaces.
高强抗渗浇注料用于电解槽底部，作为阻挡层使用。
4.
Composition and Properties of Modified Mastic Asphalt Concrete at the Jiangyin Yangtze River Bridge Pavement
江阴长江大桥钢桥面铺装层改性沥青浇注式砼的组成与性能研究
5.
Influence of Product Shape and Injection Gat Location on Breakthrough Phenomenon of Core Melt in Co-injection Molding
制品形状和浇口位置在共注射成型中芯层熔体前缘冲破的影响
6.
after the first (ground) tier of columns is erected, ceilihg floor sections are concreted on the ground. Synthetic films are inter-laid between slabs.
第一节(底层)柱子竖起来后，顶棚和楼板在地上浇注。在每层楼板之间铺上合成薄膜。
7.
Research and application of the dual-string separate-layer water injection technology
双管分层注水工艺技术的研究与应用
8.
Pour a solid foundation of cement
浇注坚实的水泥地基
9.
concreting boom
浇注混凝土起重机臂
10.
connecting rod babbitting jig
连杆巴氏合金浇注器
11.
connecting rod bearing pouring
连杆轴承巴氏合金浇注
12.
A mold for the setting of concrete.
模板浇注混凝土的模板
13.
Cast Process of Winding in Epoxy Resin Cast Dry-Type Transformer
环氧树脂浇注干式变压器的绕组浇注工艺
14.
The sand faced-iron mould casting process is a special iron castings production process, according which castings are to he cast in the iron moulds having a thin layer of the resin sand facing in their inner surfaces.
铁型覆砂铸造是指在金属型（铁型）内腔覆上一薄层树脂砂，然后采用这种覆砂铁型浇注铸件。
15.
Technology of Inclined Cast Avoid Appeared the Defects of Misrun in Oven Door Casting
倾斜浇注防止焦炉炉门铸件产生浇不足缺陷
16.
The Secondary Development of Autocad for Feed System of Injection Mold;
注塑模浇注系统的AutoCAD二次开发
17.
Design of Injection Mold Gating System of the Plastic Gear Based on MoldFlow Software
基于MoldFlow塑料齿轮注射模浇注系统设计
18.
The Design and CAE Analysis in Multy-carities Injection Moding Feed System
多型腔注塑模浇注系统设计及CAE分析