1.
Its recommended to set a temperature gauge to check the temperature of hot water.
最好安装温度计以了解温水的温度。
2.
Temperature/Blend-Air Door Motor Remove/Install
温度/混合-空气门马达拆卸/安装
3.
Temperature recording devices not located in every cold storage structure.
温度记录仪没有安装在每个冷库内。
4.
armored thermometer
带套温度计,铠装温度计
5.
Trip Computer, Compass, and Thermometer Display Module Remove/Install
行车电脑，罗盘，和温度表显示模组的拆除/安装
6.
Temperature and pressure gauges - jacket mounted for convenient viewing.
温度和压力表----可安装在热水器表面,便于观察。
7.
Numerical Simulation of Fresh Air Exchanger Effecting Indoor Environment
安装新风换气机房流场及温度场数值模拟研究
8.
Numerical Simulation Analysis on Temperature Distribution of on-site Induction Brazing of Tube
导管安装感应钎焊温度场分布数值模拟
9.
A gas condensing boiler is also installed, and is fitted with an outside temperature compensating controller.
另外，还安装了蒸汽冷凝锅炉，并且装有室外温度补偿控制器。
10.
Install a listed temperature-pressure relieve valve in the remaining fitting.
在剩下的螺纹接头上安装额定温度/水压的安全阀。
11.
Install a listed temperature-pressure relief valve in the opening on the side of the heater.
在热水器侧面的开口位置上安装额定温度/水压的安全阀。
12.
Install a shutoff valve in the cold water inlet. Install a listed temperature-pressure relief valve in the remaining fitting.
在冷水进水管上安装一个关断阀。在剩下的螺纹接头上安装额定温度/水压的安全阀。
13.
Temperature gauge or engine mounted gauge sensor defective or shorteAlso, corroded or loose wiring in the circuit.
温度计或安装在引擎上的温度感知器故障或短路，也可能是电路中的线路腐蚀或松动。
14.
Red pilot light mounted on inner door for each connected motor. Does not include temperature switches.
每台连接电机均在内门上安装红的指示灯。不包括温度开关。
15.
Use short or standard length thermostat. Vertical discharge line must be installed with its direction downward.
适用于较短或标准长度温控杆。垂直排泄管必须安装在它的下方。
16.
The Analysis of the Impact of Temperature Load on the Arch Rib Alignment of the Concrete-filled Steel Tube Arch Bridge
温度荷载对钢管混凝土拱桥拱肋安装线形的影响分析
17.
closed temperature measuring device
封闭式温度测量装置
18.
Thermometers are filled with fluids such as toluene or alcohol.
温度计装有甲苯或酒精。