1.
The Calculation of Longitudinal Load Distribution of Gear Based on BP Neural Network
基于BP神经网络的齿轮齿向载荷分布系数计算
2.
Research on Transverse Load Distribution Factors for Jointless Bridges;
无伸缩缝桥梁的荷载横向分布系数研究
3.
Investigation and Application of Transverse Load Distribution Coefficients Measured in Existing Bridge
在役桥梁实测荷载横向分布系数研究与应用
4.
Application of the measured load transverse distribution coefficient on bridge detection
实测荷载横向分布系数在桥梁检测中的应用
5.
A Research of Live-load Distribution Coefficient for T-type Flitch Beam Bridge
T形梁的组合板—梁桥荷载横向分布系数研究
6.
Analysis and Research on Sensitivity of Load Transversal Distribution Factor of T-beam by Finite Element Method
应用有限元方法对T梁的荷载横向分布系数灵敏度的分析和研究
7.
Research on Load Transverse Distribution Factors of Concrete Beam Bridge in Reinforcement Examination;
荷载横向分布系数在混凝土梁桥加固检测中的研究
8.
Research and Application of Lateral Load Distribution Factor Calculating Method for Small and Medium-span Bridges
中小跨径桥梁荷载横向分布系数计算方法的研究及其应用
9.
Stress distribution of modified bar - clip implant - borne overdenture in the edentulous mandible under verti- cal loads and oblique loads
下颌改良杆卡式种植覆盖义齿的应力分布——垂直载荷与斜向载荷的比较
10.
Calculation of Meshing Stiffness and Research on Tooth-Race Load Distribution for Herringbone Gear
人字齿轮啮合刚度计算与齿面载荷分布研究
11.
Study of Distribution Law of Dynamic Load along the Line of Action in Gear Transmission;
齿轮传动动载荷沿啮合线分布规律的研究
12.
The Contrastive Studying of Foundation Deformation under Vertical Homogeneously Distributed Load by Method of Finite Element Numerical Calculation and Spot Test Analysis
竖向均布荷载下地基变形有限元数值计算分析与实测对比研究
13.
Numerical analysis of dynamic stress variation in spur gear under impact loads
冲击载荷下的齿轮动应力变化规律数值分析
14.
The Generalized Rigid-jointed Beam Method for Calculating Lateral Distribution of Load in Curved Bridges
广义刚接梁法计算弯桥荷载横向分布
15.
Experimental Study on Vertical Load Distribution of High-stacked Culvert
高填方涵洞竖向荷载分布的试验研究
16.
irregularly distributed load
非匀布荷载;不规则分布荷载;不均匀分布荷载;不平匀分布荷重
17.
Method of Determining Load Distributing Coefficient in Holding Screw Connection of Micron Wood Fiber Molded Products
微米木纤维模压制品握钉结合部载荷分布系数的确定方法
18.
Second, measure the load of the gear and its revolutional speed in step, and change the load distribution on time into another load distribution on loaded numbers.
制谱时应把载荷时间分布按载荷—转速规律化为载荷次数分布,然后进行制谱。