1.
Development and Application of Automatic Control System of Hot Cross-cutting Line
热轧横切线自动化控制系统的开发及应用
2.
Development and Application of the Technology of Three-strand Split Rolling for φ16 Bar
φ16热轧带肋钢筋三线切分开发与应用
3.
Optimisation of the Crop Shear in 1580mm Hot Strip Mill
优化剪切控制在1580mm热轧线的实现
4.
Wire: usually produced from hot-roiled rod by drawing; smaller than 4mm in diameter usually with a round section.
线材--一般用热轧细棒材拔拉而成，:直径小于4mm，横断面一般为圆形。
5.
TRIPLE SPLITTING ROLLING OF Φ12mm HOT-ROLLED RIBBED REINFORCED BAR
Ф12mm热轧带肋钢筋的三切分轧制
6.
Study on Accurate Shaping Curve of Inside Right-angle Step of Cross Wedge Rolling
楔横轧内直角台阶精确轧齐曲线的研究
7.
Study on the influence law of the rolling curve affected by rolling radius during cam shaft cross wedge rolling
楔横轧凸轮轴轧制半径对辊形曲线影响的规律
8.
Experiment-rolling Pipeline Steel X60 in 2300 mm Hot-rolling Line of Benxi Iron & Steel(Group) Co.,Ltd.
本钢2300mm热轧机组试轧X60管线钢
9.
Optimization of the Hot Rolling Process for Narrow Strip Steel
热轧窄带钢生产线轧制工艺改造综述
10.
Improvement the Cut Water Equipment of the Work Roll of the 1750mm Hot Rolling Finishing Rolling Mill in Bayi Steel
八钢1750m m热轧精轧机工作辊切水装置的改进
11.
Research on Microstructure of Hollow Part During Hot Deformation by 3-roll Cross Wedge Rolling
三辊楔横轧空心件热变形时微观组织的研究
12.
Strip profile multi-factor description and high-quality steel rolling control in hot rolling
热轧带钢横截面多参数表示及高精度板形控制
13.
The practice of splitting rolling of continuous bar rolling line
全连续小型棒材轧机生产线切分轧制实践
14.
Application of coil box in Qian'an Iron & Steel Co.2250 HSM
热卷箱在迁钢2250热轧生产线的应用
15.
Optimization Design of Guide Post of Jinchuan 800mm HSM Shears
金川800mm热连轧剪切机导柱优化设计
16.
THE CALCULATION OF PRECISE EVEN CURVE OFVERTICAL STEP IN CROSS WEDGE ROLLING
楔横轧成形直角台阶精确截齐曲线的计算
17.
Research on the Equipment Installation Technology Optimization of Large Scale Hot Mill Continuous Rolling Line
大型热连轧轧钢生产线设备安装工艺优化研究
18.
Introduction the on-line Process Method of Electric Joint Slack for Heat Rolling and Finish Rolling
浅谈热轧精轧电机联轴器在线加工方法