1.
Conditional Yield Strength by Use of Titanium for Pressure Vessels Should be Changed from σ_(r0.2) to R_(p0.2)
压力容器用钛采用的条件屈服强度应由原标准σ_(r0.2)改为R_(p0.2)
2.
maximum shear stress yield criterion
最大剪切应力屈服条件
3.
"Yield strength 85Kg/mm2(120,000psi)maximum"
屈服强度最大85Kg/mm2(120000psi)
4.
"Maximum shear Strength 63Kg/mm2(90,000psi) maximum (based on 75% yield) "
剪切强度最大63Kg/mm2(90000psi)(为屈服强度的75%)
5.
The Test Method of Determining Residual Stress Based on Yield and Rigidity Decay;
基于屈服及刚度衰减条件测定残余应力的试验方法
6.
Local Buckling and Post-Buckling Strength of Tapered Member;
楔形压弯构件的局部屈曲及屈曲后强度
7.
Study on Increasing Yield Strength of Q345B Plate in JISCO;
提高酒钢Q345B板材屈服强度研究
8.
Research on dynamic yield strength of steel 30CrMnSiNi2A
30CrMnSiNi2A钢的动态屈服强度研究
9.
Analysis of Cracking During Stamping of 700MPa Grade Super High Strength Beam Steel
屈服强度700MPa级超高强度大梁钢冲压开裂分析
10.
Influence of strength of ferrite matrix on yield strength of granular structure steels
铁素体基体强度对粒状组织钢屈服强度的影响
11.
Experimental research and prediction of yield strength for aging strengthened aluminium alloy
铝合金时效强化的实验研究及屈服强度计算
12.
Effect of Heat Treatment System and Test Method on Yield Strength of LY12MCZ Alloy
热处理制度和试验方法对LY12MCZ屈服强度的影响
13.
It was believed that there were still disputable points deserving of further elaboration in the verification that had been so far made.
文中证明，特征线法的应力关系式与本文的屈服条件、屈服函数的极值条件是相同的。
14.
Constitutive Relation of Pear-shaped Yield Surface for Concrete under the Conditions of the Special Load
特殊荷载条件下的混凝土梨形屈服面本构关系
15.
Stability Analysis (Buckling Strength) of Members in Resistance Damage Structures under Torsion;
抗损结构中构件扭转稳定性（构件屈曲强度）分析
16.
Research on Direct Calculation of Yielding and Buckling Strength Based on CSR for Oil Tanker;
基于油船结构共同规范的屈服与屈曲强度直接计算研究
17.
Research on Direct Calculation of Yielding and Buckling Strength Based on CSR for Bulk Carriers;
基于散货船结构共同规范的屈服与屈曲强度直接计算研究
18.
Parametric Design and Research on Direct Calculation of Yielding and Buckling Strength for Deck Ship
大型甲板货船参数化设计与结构屈服屈曲强度直接计算研究