1.
Technological Improvement of Casting Bandage Construction of Water-Cooling Beam and Column in Walking-Beam Type Heating Furnace
步进梁式加热炉水冷梁柱浇注包扎施工技术改进
2.
Research on Cast-in-Place Cantilever Construction Technology of Cable-Stayed Truss Bridge
斜拉桁架桥的悬臂浇注施工工艺研究
3.
It's mainly used in ladle backing layer and tundish backing layer.
自流浇注料还可采用机械化施工。
4.
Characteristics and Key Construction Points of Cast-in-place Pile with Big Radius
大直径现浇灌注桩特点及施工要点分析
5.
The setting scheme of late poured band and attention problems in design and construction
后浇带的设置方案及设计施工中应注意的问题
6.
Research of Binding Material Construction Craft of Pipes Stepping Heating furnace;
步进式加热炉筋管包扎料施工工艺探讨
7.
On the problems that should be paid attention to in the construction of cast-in-site concrete reinforcing band of underground engineering
地下工程现浇混凝土加强带施工中应注意的问题
8.
This article gives the construction procedure and instructions for on-site casting of continuous concrete box beam with mobile mould.
介绍移动模架施工现浇混凝土连续箱梁的施工工艺,以及在施工中应该注意的事项。
9.
Technology for Long Life of Tundish and Non-stopper Steel Stream Protection of Billet Continuous Casting in ANYANG Iron & Steel Group Co. LTD;
安钢小方坯连铸中间包长寿及无塞棒控流保护浇注工艺研究
10.
One that binds, especially a bookbinder.
包扎者包扎者，尤指装订工
11.
Boron-Neutron decay logging includes boric acid injection technology and logging operations.
注硼中子寿命测井工艺包括注硼施工工艺和测井施工工艺2部分。
12.
High strength, good volume stability, low thml. Cond.，and can be installed by casting, gunning or ramming.
强度高，烧后线变化小，导热率低，可浇注、喷射、捣打施工。
13.
Research on Construction Control and Model Test of Cantilevering Casting Construction of Long-Span RC Arch Bridge;
大跨度钢筋混凝土拱桥悬臂浇注施工控制与模型试验研究
14.
Effects of alumina micro powders and water reducer on workability of corundum castables
氧化铝微粉与减水剂对刚玉质浇注料施工性能的影响
15.
cast-in-situ concrete construction
现浇钢筋混凝土施工
16.
cast-in-site concrete technique
混凝土现浇施工技术
17.
Cast Process of Winding in Epoxy Resin Cast Dry-Type Transformer
环氧树脂浇注干式变压器的绕组浇注工艺
18.
High strength, low linear change and low thermal conductivity. Forming easily, such as casting, gunning, coating, ramming.
强度较高，烧后线变化小，导热率低，施工方便，可浇注、喷射、涂抹或捣打施工。