1.
Numerical simulation of 3D turbulent flow in equality screw-pitch Inducer
等螺距诱导轮的理论分析与数值模拟
2.
Numerical Simulation of Two-phases Cavitation Flow in Equal-pitch Inducer
两相流数值模拟分析等螺距诱导轮内空化问题
3.
Use the Equidistant Alternating Theory to Calculate the Approximate Equation of Gear Tooth Profile about Spiral Bevel Gear;
计算螺旋锥齿轮近似齿廓方程等距变换法
4.
Based on the principle of dividing with pitch change gear, this paper deduces the formula of arbitrary dividing in screw grinder.
利用螺距挂轮分度的原理,推导出在螺纹磨床任意分度的公式。
5.
fixed screw propeller shrouding
定螺距螺旋桨导流管
6.
adjusting idler wheel
调整用惰轮, 履带诱导轮
7.
A Easy way of turning non Standard Screw Pitch;
车削非标准螺距螺纹的挂轮简便选配法
8.
The spiral distance formula is given by energy analysis.
用能量分析方法导出了螺距设计公式。
9.
damage the thread of(a screw)or the teeth of (a gear),esp by misuse
损坏（螺钉等）的螺纹或（齿轮）的齿（尤因使用不当）.
10.
The inductive effect decreases with increasing distance.
诱导效应随着距离的增加而减弱。
11.
Effect of Propeller Tip Clearance on Ship Hull Excited Force Induced by Propeller;
梢部间隙对螺旋桨诱导激振力的影响
12.
fixed pitch propeller
定螺距螺旋桨固定螺距螺旋桨
13.
range hand wheel
距离手轮, 距离盘
14.
Numercal Studies on Centrifugal Pump Installed Compound Impeller with Inducer;
带前置诱导轮的复合叶轮型离心泵数值研究
15.
Modeling and NC machining of two-blade equidistant wood propeller
双叶等距木质螺旋桨的三维建模与数控加工
16.
NC Milling Analysis of the Non-circular Screw Curve Parts
非圆等距螺旋曲线零件的数控铣削加工分析
17.
Discussion about the Continuity of Arc-shaped Curve of Ball-end Milling Cutting
等螺距圆弧形球头铣刀刃口曲线的连续性讨论
18.
Arc-shaped Curve of Ball-end Milling Continuity
柱状球头回转铣刀的等螺距刃口曲线研究