1.
Design of opening velocity controller for circuit breaker based on embedded technology
基于嵌入式技术的断路器分闸速度控制器的设计
2.
Construction Temperature Observation and Back Analysis of Pier-wall C25 Concrete for Caojie Sluice
草街冲砂闸闸墩C25混凝土施工温度观测反分析
3.
Application of Monte-Carlo Method in Reliability Analysis against Sliding for Gate Lock Chamber
蒙特卡罗法在水闸闸室可靠度分析中的应用
4.
Analysis on operation of rapid arc suppression coil to accelerate selection and trip of the faulty line
快速消弧线圈加快速选线跳闸的运行分析
5.
The camera adjusts its focus, lens aperture, and shutter speed by itself.
照相机会自己调整焦距、光圈和光闸速度。
6.
On the pier construction and the simulation analysis of the temperature field during maintenance
闸墩施工及养护期间温度场仿真分析
7.
Reliability Analysis of Hydraulic Steel Gates by JC Method
基于JC法的水工钢闸门可靠度分析
8.
Discussion on Reasons of Malfunction Load Rejection Over-Speed Trip for Heat Providing Turbine Generator
供热机组故障甩负荷超速跳闸原因的分析
9.
Construction of Given Speed Mode on High-speed Train Brake Testing System
高速列车闸片性能测试系统速度给定模型的构建
10.
This requirement has brought about the development of breaker operating mechanisms that are not only high-speed opening, but are also high-speed reclosing.
这种要求已促使研制出具有不仅能快速分闸而且也能快速重合闸的断路器操动机构。
11.
The Research on Application of Packet Scheduling Algorithm in Lock Scheduling;
分组调度算法在船闸调度中的应用研究
12.
It is dangerous to ride a bicycle along an icy road, so we have to use a brake to slow down the bicycle.
在冰路上骑车是很危险的，因此我们必须用车闸使自行车减慢速度。
13.
How much plant would stop on a partial shutdown?
部分自动跳闸时，工厂多大程度上停止运转?
14.
Analysis of water gate anti-polluting dispatching to alleviate water pollution influence in Huaihe River
水闸防污调度对减轻淮河水污染的影响分析
15.
The Research of the Distributed Measurement System of Sluice Opening in Hydropower Station;
水电站分布式闸门开度检测系统的研究
16.
Simulation Change of Temperature and Stress Field Analysis in a Massive Concrete Sluice Pier;
基于ANSYS的混凝土闸墩温度场及应力场仿真分析
17.
Hydraulic Characteristic Analysis and Numerical Simulation on the Outflow of Weir and Sluice under High Submerged
高淹没度下闸堰出流水力特性分析与数值模拟
18.
Strength analysis and structural optimization for large-calibred gate valve body by using AWE
基于AWE的大口径闸阀阀体强度分析与结构优化